PC 2005-21 - Laserfiche WebLink

Building 22. I/ach home shall subrrtit for a building permit, each plan set shall contain: a. An individual site plan, b. A full landscape and irrigation plan for the front and rear yards (site specific), c. A detailed fencing plan (site specific, and d_ A plan specific rnateri al board, 23. The building shall meet the applicable Title 24 state energy requirements. 24. All building and/or structural plans must comply with all codes and ordinances in effect before the Building and Safety Division will issue permits. 25. The applicant shall submit 3 full-size sets of construction plans (wet-stamped and signed, 2 sets of the necessary structural and Title 24 calculations, 2 copies o£a site specific soils report, and the completed Building Permit Questionnaire to the Building Department, along with the necessary fees, to initiate the City's plan check process- The plan chock will be accepted only after the cotripletion of~the Design Review procedure's 1 5-day appeal period, unless the applicant submits a signed statement acknowledging that the plan check fees may be forfeited in the event that the approval is overturned or the design is significantly changed as the result of an appeal. In no case will a building permit be issued prior to the expiration of the 1 5-day appeal period- 2C. A sanitary sewer sampling manhole shall be provided on any new sanitary sewer lateral from the building, unless otherwise waived by the Chief Building Official. 27. Yrior to issuance of a building permit, the applicant shall pay the applicable Zone 7 and City connection fees and water meter cost for any water meters, including irrigation meters. Additionally, the developer shall pay any applicable DSRSD sewer permit fee_ 28. The n-iain structure shall be constructed to allow for future installation of a Photo Voltaic ~PV~ system. The prgject/ building developer may either comply with the following requirements for making all houses on the Lot photovoltaic ready. Making the home photovoltaic ready shall require the following measures to be implemented with the construction of the structures covered: l~ Electrical conduit and cable shall be installed from the roo£/attic area to the buildings' main electrical panels. 2) Roof trusses shall be engineered to handle an addition load of five ~5) pounds per square foot beyond that of the anticipated load for the roofing material. 3J An area shall be provided near the electrical panel for the "inverter" required to convert the direct current output from the photovoltaic panels to alternating current. 4) A bi-directional electrical meter shall be installed. 4