ORD 1840 - Laserfiche WebLink

29. The project developer shall submit a waste management plan to the Building Department prior to issuance of building or demolition permits. The plan shall include the estimated composition and quantities of waste to be generated and how the project developer shall recycle at least fifty percent (50 %) of the job site construction and demolition waste. Proof of compliance shall be provided to the Director of Building Inspection prior to the issuance of a final building permit. During demolition and construction, the project developer shall mark all trash disposal bins "trash materials only" and all recycling bins "recycling materials only". The project developer shall contact Pleasanton Garbage Service for all waste disposal. Only that portion of trash and recycling waste refused by Pleasanton Garbage Service shall be disposed of or diverted by another trash/recycling company. 30. The driveway color and material shall be indicated on the plans submitted for issuance of building permits. Said material/color shall be subject to review and approval by the Planning Director and City Engineer prior to issuance of building permits for the project. 31. A construction staging plan shall be submitted to the Planning Director for review and approval before issuance of a grading/on-site permit. The plan shall minimize the storage o1~ construction equipment/materials on Kottinger Drive. The construction staging plan shall be implemented by the project developer/comractor/sub-contractors during all project construction phases. 32. The existing retaining wall along the Kottinger Drive frontage shall be removed and a new retaining wall installed. The following conditions shall apply to the new wall: a. The face of the wall located westerly of the proposed driveway shall be installed two feet behind the back of the curb to allow vehicles parked parallel with the curb to open their car doors, unless otherwise approved by the City Engineer. b. The wall located easterly of the proposed driveway shall be set behind a 5-foot wide monolithic sidewalk, unless otherwise approved by the City Engineer. c. Prior to issuance of a building permit, an elevation drawing of the proposed retairdng wall shall be submitted to the Planning Department for review and approval. The Planning Director shall approve the wall type and finish. d. The applicant shall install concrete swales at the top of the wall (on the backside) to intercept overland flows uphill of the wall. The applicant shall submit calculations for the wall to the City's Building Department. 33. The project developer shall submit a pad elevation certification prepared by a licensed land surveyor or registered civil engineer to the Chief Building Official and Planning