RES201194 - Laserfiche WebLink

access ways and internal drives shall not exceed 300 feet in length and shall terminate in cul- de-sacs no less than 96 feet in diameter or hammer-head(tee). Standards and options are available through the Livermore-Pleasanton Fire Department, Fire Prevention Bureau. 80. PREMISES IDENTIFICATION:Address numbers shall be installed on the front or primary entrance for all buildings. Minimum building address character size shall be 12-inch high by 1- inch stroke In all cases address numerals shall be of contrasting background and clearly visible in accordance with the Livermore-Pleasanton Fire Department Premises Identification Standards.This may warrant field verification and adjustments based upon topography, landscaping or other obstructions. 81. COMMERCIAL—NEW CONSTRUCTION:The following items shall be provided prior to any construction above the foundation or slab. a. Emergency vehicle access shall be provided to the site, including areas where construction is occurring. If Public Works Improvements are part of the project to access the site, an emergency vehicle access plan shall be submitted for review and approval to the Fire Department. b. If permanent access or site paving is not provided,the carrying capacity of the emergency vehicle access shall be 70,000 pounds under all weather conditions. c. Site staging area(s)shall be provided for materials and equipment.All staging areas shall be outside of the emergency vehicle access route shown on the approved plans. d. Where on-site fire hydrant(s)are required,they shall be installed,flushed and all valves open prior to any construction above the foundation or slab.This includes concrete tilt-up and masonry buildings. e On-site fire hydrant(s)shall not be obstructed and shall be sufficiently above grade to have all hydrant valves and outlets accessible for emergency use. f. Where a project is phased as part of the development, specific access,water supply and fire hydrant installations will be required as part of each phase.As needed a phasing plan with these improvements will be required. g. Where on-site grading/utility plans are submitted for review and approval prior to building construction drawings,emergency vehicle access routes,fire hydrant locations, material staging areas,etc. shall be provided. 82. FINAL INSPECTION: Prior to request for final inspection, all access roads,on-site access and fire hydrants shall be provided.All fire hydrants shall be accepted, inspected and tested to applicable City Standards. LANDSCAPE ARCHITECTURE DIVISION—925-931-5672 Landscaping 83. LANDSCAPING: Detailed landscape and irrigation plans encompassing all planting areas, both on-site and off-site, shall be included in the building permit plans.All plans shall be prepared by a licensed landscape architect and shall provide the species, location, size,quantities,and spacing of all plants Minimum plant sizes are 1-gallon containers for ground cover, 5-gallon containers for shrubs,and 15-gallon containers for trees. Plant species shall be of a drought- tolerant nature and the irrigation design shall utilize low-volume drip, bubbler,or other water conserving irrigation systems to the maximum extent possible.The drawings shall be subject to the review and approval of the City Landscape Architect prior to building permit issuance 84 WATER EFFICIENT LANDSCAPE ORDINANCE(WELD):The project shall comply with the P19-0128/P19-0129 City Council Page 13 of 16