2_Exhibits A & C - Laserfiche WebLink

13. BUILDING SURVEY: The applicant shall submit a building survey and/or record of survey and a site development plan in accordance with the provisions of Chapter 18.68 of the PMC. These plans shall be approved by the Chief Building Official prior to building permit issuance. The site development plan shall include all required information to design and construct site, grading, paving, drainage, and utilities. 14. PAD AND SETBACK CERTIFICATION: The applicant shall submit a pad elevation certification prepared by a California licensed land surveyor or registered civil engineer to the Chief Building Official and Director of Community Development certifying the pad elevations and building locations (setbacks) are conforming to the approved plans, prior to receiving a foundation inspection for the structures. 15. BUILDING HEIGHT CERTIFICATION: The applicant shall submit a building height certification prepared by a California licensed land surveyor or civil engineer to the Director of Community Development before the first framing or structural inspection by the Building and Safety Division. The height of the structures shall be surveyed and verified as being in conformance to the approved building heights as shown on Exhibit B or as otherwise conditioned. 16. FINAL INSPECTION: Final inspection by the Planning Division is required prior to occupancy. 17. FIREPLACES AND FIRE PITS: Fireplaces and fire pits shall be gas fireplaces, pellet fueled wood heaters, or EPA certified wood-burning appliances. The fireplace types shall be indicated on the plan and/or specification sheet(s) submitted to for issuance of building permits. (Project Specific Condition) Green Building and Sustainability Measures 18. PHOTOVOLTAIC AND SOLAR WATER HEATING SYSTEMS: The residence shall be constructed to allow for future installation of a photovoltaic (PV) system and a solar water heating system. The measures shall be shown on the building permit plans for review and approval by the Director of Community Development prior to building permit issuance. The applicant shall comply with the following requirements for making the unit on the subject site photovoltaic-ready and solar water heating-ready: a. Electrical conduit and cable pull strings shall be installed from the roof/attic area to the building's main electrical panels; b. An area shall be provided near the electrical panel for the installation of an "inverter" required to convert the direct current output from the photovoltaic panels to alternating current; c. Engineer the roof trusses to handle an additional load as determined by a structural engineer to accommodate the additional weight of a prototypical photovoltaic system beyond that anticipated for roofing; d. Plumbing shall be installed for solar-water heating; and e. Space shall be provided for solar-heating tank. 19. GREEN BUILDING — RESIDENTIAL NEW CONSTRUCTION: Prior to building permit issuance, a list of the green building measures used in the design, covered by this approval, shall be provided to the Planning Division for review and approval by the Director of Community Development. The home covered by this approval shall be designed to achieve a "certified rating" of a minimum of 50 total points, achieving at least the minimum points in each category, using BuildltGreen's current Green Points rating system. The green building measures shall be shown on the building permit plans submitted to the Building and Safety Division. Each proposed point identified shall have a notation indicating the sheet(s) the point can be found. A special inspection by the P19-0390 Planning Commission Page 3 of 11