Laserfiche WebLink
28 <br />accord with this section shall be designated as prescribed in Section 18.88.130 of this <br />chapter. <br />Chapter 18.96 SIGNS <br />18.96.020 General provisions and requirements. <br />No sign or display of any character shall be permitted except in conformity with the <br />following regulations: <br />A.Location, Height, and Size. <br />1.Except as permitted by Section 18.96.060(J) and (K) and Section <br />18.96.090 of this chapter, all signs shall be located on the same site as the use <br />they identify, provide information about, or direct attention to. <br />2.Except in a C-C or MU district, no sign shall project beyond a property <br />line. A sign projecting beyond the property line in a C-C or MU district shall be <br />attached to a building and shall not project more than four feet from the <br />building or closer than two feet to the curb line, and shall not exceed nine <br />square feet in area. Projecting signs shall be limited to one for each ground <br />floor establishment. <br />3.A projecting sign shall have a minimum clearance of eight feet above an <br />area used by pedestrians, and a minimum clearance of 15 feet above an area <br />used for vehicular movement. <br />4.No sign attached to a building shall project above the eaves or parapet <br />line. <br />5.No sign other than a directional sign shall project more than 12 inches <br />into a required interior side yard or a required rear yard or shall be closer to an <br />interior side lot than the minimum width of a required side yard on the site <br />minus 12 inches. Signs may be located in a required front yard. <br />6.No sign exceeding 24 square feet shall be visible from an R district <br />unless it shall be more than 100 feet from the R district. <br />7.No sign shall be located so as to create a safety hazard by obstructing <br />vision, or shall interfere with or resemble any authorized warning or traffic sign <br />or signal. <br />8.No sign shall exceed 250 square feet in area. <br />B.Illumination. <br />1.In an A, R, P or S district, illumination, where permitted, shall be indirect. <br />In an O or MU-T district District, illumination, where permitted, shall be indirect <br />or diffused, provided that it shall be white and that the surface brightness of a <br />sign shall not be greater than 100 foot-lamberts. In a C , MU-D or I district <br />direct illumination shall be permitted, provided that if exterior illumination is <br />closer than 200 feet to the boundary of a site or interior illumination is closer <br />Resolution PC-2019-15