Laserfiche WebLink
recycling program in effect at the time of building permit issuance. The recycling <br />container(s) shall be shown on the plans submitted for the issuance of a building <br />permit. <br />9. Mechanical Equipment, and Transformers. <br />a. The location of any pad mounted transformers shall be subject to approval of <br />the Planning and Engineering Divisions, prior to issuance of permits by the <br />Building and Safety Division. Such transformers shall be screened by <br />landscaping. All transformers shall be shown on the plans submitted for <br />issuance of building permits. The Project Developer shall attempt to locate <br />transformers at the rear of the site. Pad mounted transformers shall not be <br />installed in a PSE. <br />b. The Project Developer shall effectively screen from all first floor level views all <br />ducts, meters, air conditioning equipment, and any other mechanical <br />equipment, whether on the structure, on the ground, or on the roof, with <br />materials architecturally compatible with the building. Screening details shall <br />be shown on the plans submitted for issuance of building permits, the <br />adequacy of which shall be determined by the Director of Parks and <br />Community Services. All required screening shall be provided prior to <br />occupancy. <br />c. All mechanical equipment shall be constructed in such a manner that noise <br />emanating from it will not be perceptible beyond the property plane of the <br />subject property in a normal environment for that zoning district. <br />d. All backflow prevention devices, above ground irrigation controls, and above <br />ground irrigation meters shall be located and screened so as to minimize <br />visual impacts. The location of all backflow prevention devices, above ground <br />irrigation controls, and above ground irrigation meters and the quantity and <br />type of proposed landscape screening shall be subject to the review and <br />approval of the Director of Parks and Community Services prior to the <br />issuance of a building permit. <br />10. Parking and Transportation. <br />a. The paving sections for the on site parking and drive areas shall be designed <br />on the basis of an R -Value test and a traffic index to. carry the anticipated <br />traffic loads. This design shall be subject to the approval of the City Engineer. <br />The minimum paving section shall be two inches (2") of asphalt concrete <br />(A.C.) on a six-inch (6") asphalt base (A.B.). The minimum A.C. pavement <br />slope shall be one percent (1 %). For pavement slopes of one percent, the <br />surface runoff shall be carried in a concrete gutter to an acceptable point of <br />discharge. The minimum slope for a concrete gutter shall be 0.5 percent. <br />b. All parking spaces shall be striped, with the exception of those in the turf <br />block parking area. <br />7 <br />