RES 16837 - Laserfiche WebLink

c. That boats, trailers, campers, motor homes, and other recreational vehicles are prohibited from being parked or stored on -site. d. That the garages and driveways shall not be modified or used for storage in a manner that would interfere with the ability to park two cars within the garage for units with two -car garages, and one car within the garage and one car in the non - tandem driveway space for each unit with one -car garages. Each resident shall utilize the garages and driveways for the parking of vehicles. In addition, boats, trailers, campers, motor homes, and other recreational vehicles shall not be parked or stored on -site. 10. Prior to issuance of a building permit, the applicant shall revise the project plans to show all windows shall be recessed approximately two inches from the outside face of wall not including the trim around the windows. Vinyl cladding or wood cladding shall be utilized on all windows. The windows shall have a similar frame and sash thickness as found on a traditional wood - framed /sashed window unless the required noise mitigation for this project prevents compliance with this requirement. In addition, window mullions shall be raised and located on both sides of the glass unless the required noise mitigation for this project prevents compliance with this requirement. Manufacturer's specification sheets, details, and sections of the windows, and window treatments (sills, trim, etc.) shall be shown on the building permit plans and shall be subject to review and approval by the Director of Community Development prior to issuance of a building permit. 11. All proposed mechanical units, air conditioning equipment, blowers, make -up air units, ducts, etc. shall be shown on the building permit plans. The project developer shall effectively screen from view all ducts, blowers, air conditioning equipment, and any other mechanical equipment, whether on the structure, on the ground, or on the roof, with materials architecturally compatible with the building. Screening details shall be shown on the plans submitted for issuance of building permits, the adequacy of which shall be determined by the Director of Community Development. All required screening shall be provided prior to occupancy. 12. Prior to receiving a foundation inspection for each structure, the applicant shall submit a pad elevation certification prepared by a licensed land surveyor or registered civil engineer to the Chief Building Official and Director of Community Development, certifying that the pad elevations and building locations (setbacks) are pursuant to the approved plans. 13. All trash and refuse shall be contained completely within the approved trash enclosure. Trash containers shall be stored within the trash enclosure at all times, except when being unloaded. The trash enclosure shall be sized to accommodate trash, recycling, green waste, and commercial organics containers. 14. If allowed by the utility company, the applicant shall move the transformer north so that it is adjacent to the trash enclosure. The final location of pad- mounted transformers shall be subject to approval by the Director of Community Development prior to P16 -0588, 273 Spring Street City Council Page 3 of 21