01 - Laserfiche WebLink

EXHIBIT A 2.02 DYNAMIC CUSHIONING REQUIREMENTS OF THE SYNTHETIC GRASS SYSTEM DRAIN-MAT Contractor will install a Brock 15 MM pad in all three fields C. The dynamic cushioning of the combined turf and in-fill system (and pad if required) shall not exceed a maximum of 110 G's at 70 degrees F. per ASTM 1936-98, F355, Procedure A at any location within 30 days of the installation. The system shall not exceed 140 G's over the warranty period. D. Packing and Shipping: Deliver products in original unopened packaging with legible manufacturers' identification. All materials shall be stored in a dry place out of the direct sunlight. E. The in-fill system shall have not less than 1-1/2 pounds of Zeolight, 12 —20 mesh sieve size. 1. The material shall have a MOHS hardness of 4.2 to 4.8 2.03 PERMEABILITY REQUIREMENTS OF THE SYNTHETIC GRASS SYSTEM A. The combined turf and in-fill system shall drain vertically at a minimum of 10 inches of precipitation per hour for 24 hours continuously, without visible surface ponding. 2.04 ADHESIVE MATERIAL PROPERTIES A. Adhesive material to adhere the synthetic turf shall be: • 34-G adhesive as manufactured by Synthetic Surfaces, Inc. of Scotch Plains, NJ. • StaBond (one part adhesive), By StaBond adhesive, Gardena, CA • Mapai Ultrabond PU 1K(single component), Mapai, Deerfield Beach, FL • The adhesive shall be applied at the rate not to exceed 60 square feet per gallon. • Hot melt glue method using National Adhesives (281) 731-8949 Product #34- 5637 E. The adhesive shall have the same warranty period as the synthetic grass system. 2.05 SYNTHETIC TURF PILE SURFACE A. The pile surface shall provide good traction in all types of weather with the use of conventional "sneaker type shoes" and composition, molded sole athletic shoes.