14 - Laserfiche WebLink

of which shall be determined by the Director of Community Development, and shall be provided prior to occupancy. 6. The location of any pad-mounted transformers shall be subject to approval by the Director of Community Development prior to issuance of permits by the Building and Safety Division. Such transformers shall be screened by landscaping or contained within an enclosure matching the building and with corrugated metal gates. All transformers shall be shown on the plans submitted for issuance of building permits. 7. The approved building materials and colors shall be stated on the plans submitted for issuance of building permits. 8. All backflow prevention devices, above ground irrigation controls, and above ground irrigation meters shall be located and screened so as to minimize visual impacts. The location of all backflow prevention devices, above ground irrigation controls, and above ground irrigation meters and the quantity and type of proposed landscape screening shall be subject to the review and approval of the Director of Community Development prior to installation. 9. The proposed outdoor lighting for the subject property shall be of low intensity LED and shielded in order to minimize its visibility from off-site. Outdoor lighting shall also not glare onto adjacent properties or streets. Exterior lighting shall use the lowest wattage and shall limit the number of fixtures to attain the lowest luminosity. Fixtures shall be no greater than 14 feet in height, including any pedestal assembly, and shall be "shoebox" shielded standards or equal. The design of all lighting shall be reviewed and approved by the Director of Community Development. The lighting shall utilize photocells and timers to shut off lighting when the facility is not in use. The parking, building, and general site security lighting shall be the minimum allowed by the Police Department. The applicant shall submit a photometric plan which shall include the following: ■ Photometric calculations detailing all exterior security lighting, • Foot-candle calculations, • Fixture schedule, and • Cut sheets for light fixtures identifying the specific luminary and lamp manufacturer. 10.Prior to issuance of building or demolition permits, the project applicant shall submit a waste management plan to the Building and Safety Division. The plan shall include the estimated composition and quantities of waste to be generated and how the project applicant intends to recycle at least seventy- five percent (75%) of the total job site construction and demolition waste measured by weight or volume. Proof of compliance shall be provided to the 2