PC 2002-40 - Laserfiche WebLink

49. All private driveway aisles designated as fire lanes by the Fire Chief shall be maintained in accordance with Articles 9 and 10 of the Uniform Fire Code, which permits towing vehicles illegally parked on the fire lanes. Fire lane curbs shall be indicated by "No Park- ing, Fire Lane, Tow Away Zone" signs installed as required by the Vehicle Code. 50. All portions of the building covered by this approval shall have installed and operating, fire extinguishers with a minimum 2-A:10-B:C rating. The fire extinguishers shall be lo- cated within aseventy-five foot (75' 0") radius of each other. Engineering Requirements: 51. All utilities required to serve any existing or proposed development on-site shall be in- stalled underground. 52. The paving sections for the on-site parking and drive areas shall be designed on the basis of an R-Value test and a traffic index to carry the anticipated traffic loads. This design shall be subject to the approval of the Director of Building Inspection. The minimum paving section shall be two inches (2") of asphalt concrete (A.C.) on a six inch (6") as- phalt base (A.B.). The minimum A.C. pavement slope shall be one percent (1%). For pavement slopes less than 1%, the surface runoff shall be carried in a concrete gutter to an acceptable point of discharge. The minimum slope for concrete gutter shall be 0.5%. 53. The project developer shall submit a final grading and drainage plan prepared by a li- censed civil engineer depicting all final grades and on-site drainage control measures, in- cluding concrete-lined V-ditches, to protect all cut and fill slopes from surface water overflow. This plan shall be subject to the review and approval of the City Engineer and/or the Director of Building Inspection prior to the issuance of any building permits. 54. The project developer shall submit a refundable cash bond for hazard and erosion control prior to issuance of an Engineering or Building Department permit. The amount of this bond will be determined by the City Engineer. 55. The project developer shall grant an easement to the City over those parcels needed for public service easements (P.S.E.) and which are approved by the City Engineer or other easements, which may be designated by the City Engineer. 56. The haul route for all materials to and from this development shall be approved by the City Engineer prior to the issuance of an encroachment permit. 57. The project developer shall include erosion control measures on the final grading plan, subject to the approval of the City Engineer. The project developer is responsible for en- suring that the contractor is aware of such measures. No grading shall occur between Oc- tober 15 and April 15 unless approved erosion control measures are in place, subject to -__ __ PDR-225, Exhibit "B ", f'rna! Conditions Page 7 oJlO July 10, 2002