ORD 2003 - Laserfiche WebLink

64. A minimum, two -inch diameter water main with a pressure reducing valve, limiting the pressure to be at 85 psi or lower, shall be provided to each lot, unless otherwise approved by the City Engineer. The water meter box on the water lateral shall be located by the side of the private street off the pavement. The approved locations for the laterals and boxes shall be shown on the Improvement Plans submitted with the parcel map to the satisfaction of the City Engineer and the Planning Division. Public /Private Utility Installation and /or Modification Sewer 65. The applicant shall revise the sanitary sewer lateral to Lots 3 and 4 to include individual force mains and grinder pumps for each of the homes on these lots. The sanitary sewer pumps and force mains shall be private and shall be maintained by the individual property owners. A permanent disclosure of this fact shall be recorded over these lots with the recordation of the parcel map. Wording for the disclosure shall be submitted to the City Attorney and the City Engineer prior to recordation of the parcel map. 66. The existing sanitary sewer main shall remain private and shall be maintained by the Maintenance Association (MA) created for this purpose including the four Fuller/ Smathers properties directly to the west of this development. Prior to submittal of the parcel map application to the Planning Division, the applicant shall execute a written agreement with the Fuller /Smathers stating their consent of the use of this sanitary sewer main by the residents of this development, and Fuller /Smathers participation in the MA. A copy of the fully executed agreement shall be submitted to the satisfaction of the City Engineer and the Planning Division before the parcel map application can be determined complete. 67. The applicant shall show the location of all easements necessary to convey drainage on the parcel map 68. The applicant shall install a two -way cleanout on the sanitary sewer lateral to each lot. Public /Private Utility Installation and /or Modification Electrical 69. The applicant shall underground the existing electrical lines traversing the project site along its northerly boundary line as part of the development. 70. All utility boxes, transformers, capacitor banks, and /or switches for this development shall be installed underground in conduit. Their locations and design details shall be shown on the improvement plans submitted with the parcel map for review and approval. The capacitor banks or switches may be installed above ground, if properly screened subject to the review and approval of the Planning Division. Subdrains 71. Where an existing drainage swale will be filled, the applicant shall provide subdrains unless otherwise recommended by the applicant's Soils Engineer and approved by the City Engineer. The subdrains shall have a cleanout installed at the beginning of the pipe, and the bottom of the pipe shall terminate in a storm drain or other storm drain outfall subject to the approval of the City Engineer. The applicants engineer shall submit a final subdrain location map to the City Engineer prior to acceptance of the public improvements for this development. It shall be the responsibility of the owner(s) 17