ORD 2003 - Laserfiche WebLink

of the total water usage based upon the reading of the master meter. It will then be the responsibility of the MA to bill the individual lot owners for the differences between the City's master meter and the individual private water meters. 59. The master meter that the applicant is responsible for furnishing and installing shall be a "Fireline" type meter installed in an appropriately sized vault with an acceptable cover, each to be approved by the City Engineer. The sizing and manufacturer of said meter will be determined by the City Engineer but will take into consideration the need to accurately measure all domestic, irrigation and fire flows that are anticipated within the Yee development and any existing or new homes within the Fuller /Smathers development or property. In addition, the applicant will be responsible for furnishing and installing an "excess flow" type valve on the Fuller /Smathers private water system pipeline at a location and type acceptable to the City Engineer. The applicant shall be responsible for the cost of any additional telemetry equipment, wiring or SCADA improvements necessary to connect and properly monitor the aforementioned equipment within the City's existing SCADA system. 60. A maintenance agreement for the water main including the individual Pressure Reducing Valves (PRV) on the water services shall be submitted for review and approval of the City Attorney and the City Engineer prior to the approval of the parcel map. The agreement shall include the provision, if the City of Pleasanton is contacted by the residents or the Maintenance Association (MA) regarding the maintenance and /or repair of the private water line and the City water crews are called out to investigate the problem, if it is determined that the City's public water supply is not responsible for the problem, the resident or the MA shall be responsible for the cost of City water crews on a time and materials basis. 61. The water main shall be designed, installed and inspected in accordance with City Standards including the installation of pressure reducing stations as determined by the City Engineer to reduce and maintain the water main pressure at or below 120 psi. The specifications for the water main shall be submitted with the Improvement Plans submitted with the parcel map for approval of the City Engineer. 62. Unless otherwise approved by the City Engineer, the water mains for this development shall be constructed of welded steel pipe or of ductile iron pipe with T.R. -flex fittings. The applicant shall retain a certified inspection firm to inspect the pipe installation and to certify the pipe welds or the flex fittings to the satisfaction of the City Engineer before closing the trench. The entire water main system shall be protected from corrosion with a Cathodic Protection System (CPS), designed and inspected by a corrosion engineer registered in the State of California to the satisfaction of the City Engineer. The applicant shall provide copies of the inspection reports to the City Engineer before closing the trench. 63. The applicant shall design and install the water main for this development to provide for the extension of a private water main to the lots of Tract 6275 to the south. The details shall be shown on the Improvement Plans submitted with the parcel map for the review and approval by the City Engineer and the Planning Division. The applicant of this development shall not object to the developer of Tract 6275 from annexing into the maintenance agreement for the water main between Fuller /Smathers and this applicant (Yee). 16