PC 2001-17 - Laserfiche WebLink

Resolution No. PC-01-17 Page 16 54. The site shall be kept free of fire hazards from the start of construction to final inspection. BUILDING 55. The applicant shall obtain a building permit, and any other applicable City permits for the project prior to the commencement of any construction. 56. All buildings and/or structural plans must comply with all codes and ordinances in effect before the Building Department will issue permits. 57. Building and sims plans are to be submitted to the Building Department on computer disk in a format approved by the Director. Digitized information shall be submitted before requesting a final inspection and should reflect as-built situs and architectural information as approved by the Director. 58. All dwelling units in the development shall be constructed to meet Title 24 state energy requirements. 59. The developer shall submit a building survey and/or a record of survey and a site development plan in accordance with the provisions of Chapter 18.68 of the Municipal Code of the City of Pleasanton. These plans shall be approved by the Director of Building Inspection prior to the issuance of a building permit. The site development plan shall include all required information to design and construct site, grading, paving, drainage and utilities. Specific items to be indicated on the site development plan necessary to construct the improvements are to be in accordance with the City of Pleasanton Private Development Design Guidelines adopted April 15, 1986. 60. The developer shall submit two copies of the site soils report to the Director of Building Inspection for third party peer review and shall pay for such review at the time specified by the Director, but in all cases before the issuance of a grading permit and prior to the issuance of any individual house building permit. 61. The soils engineer shall certify the pad compactions of all lots containing fill to the satisfaction of the Director of Building Inspection prior to the issuance of building permits. 62. All retaining walls higher than four feet from the top of the wall to the bottom of the footway shall be constructed of reinforced concrete or shall be an approved crib wall type. Calculations signed by a registered civil engineer shall accompany the wall plans. 63. The paving sections for the on-site parking and drive areas shall be designed on the basis of an R-Value test and a traffic index to carry the anticipated traffic loads. This design shall be subject to the approval of the Director of Building Inspection. The minimum paving section shall be 2" A.C. on 6" of A.B. The minimum A.C. pavement slope shall be 1%. For pavement slopes of less than