04 - Laserfiche WebLink

Ordinance No. 1985 Page 7 of 17 * Lot 2 main structure setbacks are measured from the new attached carport. '" Accessory structure setbacks are measured from the property lines, unless otherwise noted. Class II structures follow the RM-15 standards. *** Heights are measured from the lowest finished grade to the highest ridge point. FAR is calculated per the PMC. 15. Except as amended by this development plan, the uses and site standards for this project shall be those of the RM-1,500 Zoning District. 16. Fencing within the PUD shall conform to the fencing plan. Modifications of the fencing plan shall be reviewed and approved by Zoning Administrator. 17. Accessory structures proposed for the development shall be designed to be open and to not have solid walls in order to maintain as much open space on each site as possible, except as noted in Condition No. 20 below, related to storage. 18. Only natural gas burning fireplaces or USEPA-approved wood/pellet burning stoves shall be allowed. This detail shall be shown on the building permit plan set. Planning 19. Prior to building permit submittal, the applicant shall pay one half of the assessed value (1/2 of $5,100.00 = $2,550.00) of the Pecan tree (tree number 1 in the Arborist report) to the Urban Forestry Fund. 20. The applicant shall provide two parking spaces (one space shall be covered) on-site per unit. Each space must have a minimum dimension of 10 feet by 20 feet (10' x 20') and cannot be tandem. The private access drive should remain clear for fire and life safety response. All carports shall be provided with storage units that shall be attractive and consistent with the architecture of the existing units, subject to the review and approval of the Director of Community Development. Garages shall be available for parking at all times. 21. The applicant is encouraged to use permeable paving for the driveways and hardscape areas; sidewalks, patios, etc. Details shall be provided on the building permit plan set to the satisfaction of the Planning Division before issuance of a building permit. 22. The applicant shall provide automatic opening sectional roll-up garage doors on the garages of the single-family houses covered by this approval. The door design and material shall be to the satisfaction of the Director of Planning and Community Development. 23. The applicant shall provide high quality siding material on the homes covered by this approval. The siding shall be reviewed and approved by the Director of Planning and Community Development. 24. The applicant shall revise the window designs to contain windowsill with trim board under each window. All windows shall be single hung. All proposed arched windows shall be recessed. The windows and window designs shall be reviewed and approved by the Director of Planning and Community Development, prior to building permit