14 ATTACHMENTS - Laserfiche WebLink

8. On-site parking is only allowed in the garages (for Homes A-D) and in the two designated parking spots for the existing home. Parking is prohibited anywhere within the joint-access driveway. Moving, delivery, and any other type of service vehicle must either park in the home's garage or designated parking spot, or park off-site. 9. Prior to the demolition of any existing structure(s) located on the property, the applicant shall have the structures examined for the presence of lead, lead-based paint, and/or asbestos by a qualified environmental professional. If lead and/or asbestos are found to be present, demolition of these structures shall be conducted in accordance with the applicable requirements of the California Department of Industrial Relations (Cal-OSHA) for lead, and Cal OSHA and the Bay Area Air Quality Management Board (BAAQMD for asbestos. The applicant shall provide to the Planning Director afollow-up report within 30-days after demolition of the structure(s) is completed. 10. Prior to the issuance of a building permit, the project developer shall submit details and/or a spec sheet of the proposed exterior doors to the Planning Department for review and approval by the Planning Director. 11. Only gas fireplaces, pellet fueled wood heaters or EPA certified wood-burning appliances may be installed in new or renovated homes. 12. All residences in the PUD shall be constructed to allow for future installation of a Photovoltaic (P~ system. The project/ building developer shall comply with the following requirements for making all houses on the property photovoltaic ready. Making the home photovoltaic ready shall require the following measures to be implemented with the construction of the structures covered: 1) Electrical conduit and cable pull strings shall be installed from the roof/attic area to the buildings' main electrical panels. 2) Roof trusses shall be engineered to handle an addition load of five (5) pounds per square foot beyond that of the anticipated load for the roofing material. 3) An area shall be provided near the electrical panel for the installation of an "inverter" required to convert the direct current output from the photovoltaic panels to alternating current. These measures shall be shown on the building permit plan set submitted to the Planning Director for review and approval before issuance of the first building permit. The project developer shall provide the future homeowners the necessary information delineating the means by which photovoltaic panels can be applied to the roofs of the structures covered by this approval. This information shall be submitted tot the Planning Director for review and approval prior to the occupancy of the first unit. 3