ORD 1940 - Laserfiche WebLink

30. The homes covered by this approval shall be constructed to encourage telecommuting by providing as an option telecommunications infrastructure consistent with state-of-the-art methods at the time that the homes are submitted for site-specific design review approval. 31. The project developer shall submit a waste management plan to the Building and Safety Division prior to issuance of building or demolition permits. The plan shall include the estimated composition and quantities of waste to be generated and how the project developer intends to recycle at least 50-percent of the total job site construction and demolition waste measured by weight or volume. Proof of compliance shall be provided to the Chief Building Official prior to the issuance of a final building permit. During demolition and construction, the project developer shall mark all trash disposal bins "trash materials only" and all recycling bins "recycling materials only". The project developer shall contact Pleasanton Garbage Service for the disposal of all waste from the site. 32. Trellis-covered arbors and/or porches up to a height of 15 feet supporting photovoltaic panels shall be exempt from the City's Administrative Design Review procedures. Design review at the Planning staff level and building/electrical permits will still be required. 33. The project developer shall provide to the buyers of the houses covered by this approval, photovoltaic systems as an option. With the building permit plan set, the project developer shall show the installations for each of the buildings covered by this approval to the satisfaction of the Planning Director before issuance of a building permit. 34. The project developer shall implement the following measures with the construction of the structures covered by this approval so that the owners can install roof- mounted photo-voltaic systems in the future: a. Electrical conduit and pull strings shall be installed from the roof/attic areas to the buildings' main electrical panels. b. Roof trusses shall be "engineered" to handle an additional load of five pounds per square foot beyond that of the anticipated for roofing. c. An area shall be provided near the electrical panel for the "inverter" required to convert the direct current output from the photovoltaic panels to alternating current. d. A bi-directional electrical meter shall be installed. These measures shall be shown on the building permit plan set submitted to the Planning Director for review and approval before issuance of the first building permit. The project developer shall provide to the future homebuyers the necessary information delineating the means by which photovoltaic panels can be applied to the roofs of the structures covered by this approval. This 9