PC 2005-14 - Laserfiche WebLink

"fhis change shall be included in the construction drawings submitted for plait check prior to the issuance of a building permit_ The revisions are subject to the review and approval of the Planning Director. Building and Engineering 16_ The height of the structure shall be surveyed and verified as being in conformance to the approved building height as shown on Exhibit "A" or as otherwise conditioned. Said verification is the project developer's responsibility, shall be performed by a licensed land surveyor or civil engineer, and shall be completed and provided to the Building and Safety Division before the t3rst trairiing or structural inspection by the Building and Safety Division_ 17. The proj act developer shall submit a pad elevation ccrti$cation prepared by a licensed land. surveyor or registered civil engineer to the C7hief Building OFficial, certifying that the pad elevations and building locations setbacks) are pursuant to the approved plans, prior to receiving a foundation inspection for the structure. 18. All metal roofs shall be t3nished with rust-inhibitive paint_ The project developer shall state so on the construction drawings submitted for plan check and building permits. 19. Roof drains shall discharge and drain away from the building foundation to an unpaved area wherever practicable_ 20_ Prior to the issuance of a building permit the project developer shall submit a grading and drainage plan to the Building and Safety Division_ The grading and drainage plan shall be subject to the review and approval of the Chief Building Off ci al, the Planning Director, and the Director of Public Works. The project developer shall include erosion control/storm water quality measures on the fiinal grading plan which shall specifically address measures to prevent soil, dirt, and debris from entering the storm drain systetri. Such mesas urns may include, but are not limited to, hydroseeding, hay bales, sandbags, and siltation fences and are subject to the review and approval of the City f :ngineer/Director of Building Inspection_ If no grading plan is required, necessary erosion control/storm water quality measures shall be shown on the site plan submitted for an on-site permit, subject to the review and approval of the Director of Building hispection. The project developer is responsible for ensuring that the contractor is aware cif and iizzplcizzc:nts such n~eas arcs. 21 _ All cut and fill slopes shall be revegetated and stabilized after completion of grading, but in no case later than October 15. Hydroseeding shall be accomplished before September 7 5 and irrigated with a temporary irrigation system to cn sure that the grasses arc established before October 15_ No grading shall occur between October 15 and April 15 unless approved erosion control/storm water quality measures are in place, subject to the approval of City Engineer/Director of Building Inspection. Such measures shall be maintained until such time as permanent landscaping is place. 3