PC-95-86 - Laserfiche WebLink

Resolution No. PC-95-86 Page 5 construct the improvements are to be in accordance with the City of Pleasanton Private Development Design Guidelines adopted April 15, 1986. c. All retaining walls higher than four feet from the top of the wall to the bottom of the footway shall be constructed of reinforced concrete or shall be an approved crib wall type. Calculations signed by a registered civil engineer shall accompany the wall plans. d. The applicant shall submit plot plans for each of the residential lots showing building setbacks and a topographic plan showing grading and drainage. Pad elevations, finish floor elevations, retaining walls, easements, and maximum height of the highest structure are to be indicated on the plan. Plans for custom lots are to be signed by a registered civil engineer. All residential plot plans shall show compliance with 2907(d) and 70012(d) of the Uniform Building Code. e. The soils engineer shall certify the pad compactions of all lots containing fill to the satisfaction of the Director of Building Inspection prior to the issuance of building permits. f. Building and situs plans are to be submitted to the Building Department on computer disk in a format approved by the Director. Digitized information shall be submitted before requesting a final inspection and should reflect as-built situs and architectural information as approved by the Director. g. The applicant shall post address numerals on the building so as to be plainly visible from all adjoining streets or driveways during both daylight and night time hours. h. All dwelling units in the development shall be constructed to meet Title 24 state energy requirements. 14. Fire Department Requirements: a. The development shall meet all requirements of the Pleasanton Fire Code (Chapter 20.24 of the Pleasanton Municipal Code) . b. The site shall be kept free of fire hazards from the start of construction to final inspection.