PC-95-43 - Laserfiche WebLink

Resolution No. PC-95-43 Page 9 c. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing in the storm drain system. Maintain and/or replace filter materials to ensure effectiveness and to prevent street flooding. d. Create a contained and covered area on the site for the storage of bags, cement, paints, oils, fertilizers, pesticides, or other materials used on the site that have the potential of being discharged into the storm drain system through being windblown or in the event of a material spill. e. Never clean machinery, equipment, tools, brushes, or rinse containers into a street, gutter, or storm drain. Ensure that concrete/gunite supply trucks or concrete/plaster operations do not discharge wash water into street, gutters, or storm drains. 39. A sanitary sewer sampling manhole shall be provided on each of the sanitary sewer lateral from each building, unless otherwise waived by the Director of Building Inspection. 40. Prior to issuance of a building permit, the applicant shall pay the applicable Zone 7 and City connection fees and water meter cost for any water meters, including irrigation meters. Additionally, the developer shall pay any applicable DSRSD sewer permit fee. 41. All retaining walls higher than four feet from the top of the wall to the bottom of the footway shall be constructed of reinforced concrete or shall be an approved crib wall type. Calculations signed by a registered civil engineer shall accompany the wall plans. 42. The applicant shall submit two copies of the site soils report to the Director of Building Inspection for third party peer review and shall pay for such review at the time specified by the Director, but in all cases before the issuance of a grading permit. 43. Building and situs plans are to be submitted to the Building Department on computer disk in a format approved by the Director. Digitized information shall be submitted before requesting a final inspection and should reflect as-built situs and architectural information as approved by the Director.