ITEM 5 EXHIBITS A-H - Laserfiche WebLink

Page 17 • Windows considered suitable for viewing shall have an approximately 36-inch maximum sill height above finish floor. • Approximately 44-inch minimum hallway width and approximately 32-inch minimum clear door opening width for all doorways within units (baseboard may encroach into the minimum hallway width). • Lever-type handles on all doors. • An approximately 18-inch minimum clear floor space beside door on pull side at the latch jamb. • All receptacle or other wall outlets, approximately 18-inch minimum height to bottom of outlet box above finish floor. • Rocker type light switches installed approximately 44 to 48 inches to top of outlet box above finish floor, and thermostats approximately 48-inch maximum height to all operating buttons or features. • Variable height (approximately 28 to 42 inches above finish floor) work surfaces such as cutting boards, countertops, sinks, and/or cooktops in kitchens. A minimum of two approximately 15-inch wide cutting boards at variable heights may satisfy this requirement. • Loop handle pulls on drawers and cabinet doors or touch hardware instead of knobs. • Full-extension pull-out drawers, shelves, and racks in base cabinets. • Full height pantry storage, with easy access pull-out and/or adjustable height shelves. • Front-mounted controls on all appliances where practical and whenever requested by residents. • Adjustable height closet rods and shelves, or the installation of backing to provide for future adjustable height rods and shelves as needed by residents. • Single-lever water controls at all plumbing fixtures and faucets. • Hand-held shower head, or combination shower head with hand -held capability. • Blocking in walls around toilet, tub, and shower for future installation and/or relocation of grab bars. 43. UNIVERSAL DESIGN – 15 OR MORE UNITS – ADDITIONAL CRITERIA: Unless otherwise approved by the Director of Community Development, a minimum of one unit for each bedroom type offered (one-bedroom, two-bedroom, etc.) and a minimum of five percent of all units required to be adaptable shall provide the following features: • A roll-in shower. • Variable height (28 to 42 inches above finish floor) permanently fixed work surfaces such as countertops, sinks, and/or cooktops in kitchens with a minimum of one 30-inch wide countertop. Pull-out countertops or cutting boards will not satisfy this requirement.