04 - Laserfiche WebLink

0644232 Brake Reservoirs, 4,272 Cubic Inch Minimum Capacity, Saber FR/Enforcer BRAKE SYSTEM The brake system will include: Brake treadle valve Heated automatic moisture ejector on air dryer Total air system minimum capacity of 4,272 cubic inches Two (2) air pressure gauges with a red warning light and an audible alarm, that activates when air pressure falls below 60 psi Spring set parking brake system Parking brake operated by a push-pull style control valve A parking "brake on" indicator light on instrument panel Park brake relay/inversion and anti-compounding valve, in conjunction with a double check valve system, with an automatic spring brake application at 40 psi A pressure protection valve to prevent all air operated accessories from drawing air from the air system when the system pressure drops below 80 psi (550 kPa) 1/4 turn drain valves on each air tank The air tank will be primed and painted to meet a minimum 750 hour salt spray test. To reduce the effects of corrosion, the air tank will be mounted with stainless steel brackets. 0568012 Air Dryer, Wabco System Saver 1200, Heater, 2010 BRAKE SYSTEM AIR DRYER The air dryer will be WABCO System Saver 1200 with spin-on coalescing filter cartridge and 100 watt heater. 0000790 Brake Lines, Nylon BRAKE LINES Color-coded nylon brake lines will be provided. The lines will be wrapped in a heat protective loom in the chassis areas that are subject to excessive heat. 0000854 Air Inlet, w/Disconnect Coupling AIR INLET One (1) air inlet with 3D series male coupling will be provided. It will allow station air to be supplied to the apparatus brake system through a shoreline hose. The inlet will be located forward in the driver side lower step well of cab. A check valve will be provided to prevent reverse flow of air. The inlet will discharge into the "wet" tank of the brake system. A mating female fitting will also be provided with the loose equipment. 0615609 Fittings, Compression Type, Entire Apparatus, Single Rear Axle COMPRESSION FITTINGS ONLY Any nylon tube on the apparatus that is pneumatic will be plumbed with compression type fittings where applicable. Push lock fittings will not be acceptable for any pneumatic nylon tube plumbing. 0808515 Engine, Paccar MX, 510HP, 1850 lb- ftW/OBD, EPA 2027, Enforcer ENGINE The chassis will be powered by an electronically controlled engine as described below: Make: Paccar Model: MX Power: 510 hp at 1600rpm Torque: 1850 lb-ft at 1000rpm Governed Speed: 1900 rpm Emissions Certification: EPA 2027 Fuel: Diesel Cylinders: Six (6) Displacement: 13.7L Starter: DP60 Fuel Filters: Dual cartridge style with check valve, water separator, and water in fuel sensor The engine will include On-board diagnostics (OBD), which provides self diagnostic and reporting. The system will give the owner or repair technician access to state of health information for various vehicle sub systems. The system will monitor vehicle systems, engine and after treatment. The system will illuminate a malfunction indicator light on the dash console if a problem is detected. 0000000 STF Engine Contingency Adjustment 0001244 High Idle w/Electronic Engine, Custom HIGH IDLE A high idle switch will be provided, inside the cab, on the instrument panel, that will automatically maintain a preset engine rpm. A switch will be installed, at the cab instrument panel, for activation/deactivation. The high idle will be operational only when the parking brake is on and the truck transmission is in neutral. A green indicator light will be provided, adjacent to the switch. The light will illuminate when the above conditions are met. The light will be labeled "OK to Engage High Idle." 8717Bid #: