13 - Laserfiche WebLink

damage caused by paint, solutions, or the processes of cleaning and painting. Additional protection shall be provided for all public and private property within the worksite or adjacent areas including landscape features, infrastructure, structures, and other surfaces not to be painted but within the work zone. The worksite and adjacent areas must be completely restored to the general condition and appearance as were before the work began. 3.1 Submittals A written scope of work detailing surface preparation and painting procedures shall be submitted with the bid. Upon the request of the City, Contractor should also provide the coating manufacturer's name, product data for each coating, including generic description, complete technical data, surface preparation, and application instructions. The bidder shall procure coatings and coating application accessories from a single coating manufacturer. After work authorization approval, samples of the color specified shall be submitted for approval. 3.2 Environmental Requirements 3.2.1 Contractor shall prepare surfaces and apply and cure coatings within the air and surface temperature range in accordance with the manufacturer's instructions. 3.2.2 Contractor shall maintain surface temperatures to a minimum of five (5) degrees F (three (3) degrees C) above dew point at the time of final surface preparation, material mixing, and application. 3.2.3. Contractor shall prepare surfaces and apply and cure coatings within the relative humidity range in accordance with the coating manufacturer's instructions. 3.2.4. Contractor shall not prepare surfaces or apply coatings in rain, snow, fog, or mist. 3.2.5. Contractor shall not spray coatings if wind velocity is above the coating manufacturer's limit. 3.3 Dust and Contaminants Contractor shall schedule coating work to avoid excessive dust and airborne contaminants and shall take the necessary steps to protect work areas from excessive dust and airborne contaminants during the coating application and curing process. 3.4 Protection of Surfaces Not Scheduled to be Coated 3.4.1 Contractor shall protect surrounding areas and surfaces that are not scheduled to be coated from damage during surface preparation, and the application of coatings. 3.4.2 Contractor shall immediately remove coatings that fall on surrounding areas and surfaces that are not scheduled to be coated. 3.5 Surface Preparation 3.5.1 Cleaning All surfaces to be painted shall be scraped or wire brushed to remove all flaking or loose paint. Wire wheels and/or cup brush grinder