10_Exhibit A - Laserfiche WebLink

Objective Design Standards for Housing Sites City of Pleasanton - 47 - Adopted January 26, 2023 Single Family Tract Development Single Family Homes and Primary Structures of Multiple Single Family Development on the same parcel shall comply with the following massing standards: B1.3 Elevations fronting Public Streets, Internal Streets, Paseos, Open Spaces, or the City of Pleasanton Trail System shall limit any continuous plane to 40% of the total façade length through the use of recesses or projections not less than three feet in depth from the adjacent wall. B1.4 Garages shall comply with the following standards: a. Garages shall not be oriented to face Paseos or the city public Trail System b. Garages facing Public Streets and Internal Streets shall be limited to i. 30% of the total width of the home façade, for lot frontages over in excess of 80 feet wide ii. 40% of the total width of the front home façade, for lot frontages over between 60 to 80 feet wide, 0. 50% of the total width of the front home façade, for lot frontages less than 60 over 45 feet wide . iv.iii. or 22 feet garage interior clear width, whichever is greater, v.iv. For parcels under 10,000 square feet s.f. three- car garages shall use tandem parking for third space within the garage. B1.5 a. Residential floor area for each floor above the ground floor shall comply with the following standardsnot exceed 75% of the ground floor area inclusive of any attached garages.: a. Floor area of any floor above the ground floor shall be no greater than: i. 40% of allowed building coverage for lots greater than 8,000 square.feet. ii. 50% of allowed building coverage for lots of greater than 6,500 square feet and up to 8,000 square feet. iii. 60% of allowed building coverage for lots over 4,500 square feet and up to 6,500 square feet. iv.80% of allowed building coverage for lots up to 4,500 square feet. b. Floor area located under sloping roofs shall be counted in accordance with the ANSI Z765 standard: .i. Residential floor area above the ground floor must have a minimum clearance of 5 feet above the finished floor .ii. 50% of the floor area above the ground floor must have ceilings at least 7 feet above the finished floor.