Laserfiche WebLink
that smaller lots would be allowed to have larger upper stories (as a percentage <br /> of allowed building coverage), compared to larger lots (the percentages and <br /> wording were modified subsequent to the January Planning Commission <br /> meeting); <br /> • Modification that in single-family developments the porch must be scaled to be <br /> 20 percent of the frontage width of the building (where 10 percent was identified <br /> in the December 2022 ODS); <br /> • Requirement that in single-family development garages accessed from the street <br /> are to be recessed a minimum of approximately six feet behind the front building <br /> fagade facing the street; <br /> • Clarifying language to indicate buildings entirely under approximately 40 feet in <br /> height or less must provide a roof slope greater than approximately three to 12 <br /> inches (3:12) at the perimeter of the building, but that buildings with varied <br /> heights that are above and below approximately 40 feet may include either flat or <br /> sloped roofs (or a combination) with the intent of maintaining architectural <br /> consistency; <br /> • Clarification regarding building materials that trim and architectural molding not <br /> be made from foam base (where the December 2022 ODS indicated trim and <br /> architectural molding be "a different materials than the surrounding wall"); <br /> • Clarification that a building must provide a significant architectural element when <br /> located at the terminating end of a view corridor, (after the January 2023 <br /> Planning Commission hearing, language is proposed to indicate this requirement <br /> would apply to buildings greaterthan three stories in height), <br /> • Requirement that development on sites less than approximately three acres <br /> containing multiple buildings with varying height must locate the tallest <br /> structure(s) furthest from the property line abutting single-family land uses; <br /> • Requirement that multifamily development on sites approximately three acres or <br /> greater locate the tallest structure(s) at the interior of the site or at frontages <br /> adjacent to arterial or collector streets; less tall structures shall be positioned on <br /> the portions of the property located closest to existing residential development <br /> (similarly, development on sites less than approximately three acres must locate <br /> the tallest structures furthest from property lines abutting existing single-family <br /> land uses), <br /> • Addition of a design guideline that development directly bordering existing <br /> single-family land uses seek to match or reflect as far as possible the existing <br /> setbacks of the adjacent single-family land uses; that enhanced landscaping be <br /> provided along shared property lines and clarification regarding language for <br /> increased setback for floors above the lower height residential development; <br /> • Clarification that the protypes in the appendix apply to multifamily development <br /> types only; <br /> • Addition of a definition of"Active Frontage" in the glossary, <br /> • Modification to language for sites that require legislative action; <br /> • Modification to bicycle parking standards; <br /> • Addition of a definition of"Development Site" in the glossary and inclusion in the <br /> text, instead of use of the terminology, "net area"; <br /> • Modification to site development standards to for alley-accessed lots; <br /> Page 7 of 10 <br />