Laserfiche WebLink
• <br /> before the following coat is applied. "Orange peel" surfacing will not be <br /> acceptable. <br /> 3. CONVERSION SPECIFICATIONS <br /> 3.1. Exterior <br /> 3.1.1. Two (2) 26" x 26" (approx.) '/z-slide windows with screens shall be installed in the <br /> side walls as depicted in the concept drawing(s). Exact sizes shall be determined <br /> during engineering refinement with the selected vendor, but generally match the <br /> preliminary drawing. <br /> 3.1.1.1. Windows shall be dark tinted. <br /> 3.1.1.2. All glass furnished shall be automotive approved safety type. All glass <br /> shall be safety glazed and meet DOT GMVSS 205, SAE recommended <br /> practice J673b and J674a, and ANSI "Safety Code for Safety Glazing <br /> Materials" Z26.1-1977 as supplemented by Z26.1 a-1980 <br /> 3.1.2. Two (2) 14" x 22" single dome white acrylic skylights shall be installed with white <br /> PVC interior trim. <br /> 3.1.3. One(1)underbody generator mounting system shall be fabricated for the generator. <br /> This system shall be located forward of the rear axle, driver side. <br /> 3.1.3.1. Generator shall be mounted for easy access for removal, service and <br /> repair. Generator access door shall be fully locking and reinforced. A remote <br /> start/stop switch with hour meter and diagnostic code display shall be <br /> installed inside near the staff workstations. <br /> 3.1.4. One (1) auxiliary battery compartment shall be installed to house the auxiliary <br /> battery bank. Compartment shall contain a slide tray(or trays) with positive latch <br /> and hold downs for ease of battery maintenance. Tray shall be lined with an <br /> isolation material to help prevent battery corrosion. <br /> 3.1.4.1. Compartment shall be constructed of aluminum or equivalent materials. <br /> 3.1.4.2. Door shall be constructed of aluminum and vertically hinged with '/4" pin <br /> stainless steel continuous hinges. <br /> 3.1.4.3. Door shall have positive "compression" style, "slam latch", or equivalent <br /> latches and a door hold-back device. <br /> 3.1.5. Two (2) general storage compartments shall be installed below the floor of the <br /> vehicle. Compartments shall be of maximum size available and located based on <br /> final design. These compartments shall be sealed to prevent moisture penetration. <br /> 3.1.5.1. Compartments shall be constructed of aluminum or equivalent materials. <br /> 3.1.5.2. Doors shall be constructed of aluminum and vertically hinged with '/4" pin <br /> stainless steel continuous hinges. <br /> City of Pleasanton Outreach Vehicle Specifications(Version 1.1) Page 10 of 23 <br />