13 - Laserfiche WebLink

a. The entry door to the room must be at the end of a hallway or passageway,or open directly from another room on an accessible route of travel, so that no turn of ninety (90)degrees or more is necessary to enter the room. b. The hallway wall opposite the room must be inset enough to allow an area of at least eight(8) inches deep with at least a sixty(60)inch run centered on the center of the entry door opening[e.g.,an eight(8)inch by sixty(60)inch notch or alcove.l c. The hallway wall on the same side as the room must be inset enough to allow an area of at least eight(8) inches deep with at least a sixty(60)inch run centered on the center of the entry door opening[e.g.,an eight(8)inch by sixty(60) inch notch or alcove.} d. The hallway wall directly opposite the room door must open to another room with at least a sixty(60)inch opening on a level with the accessible passageway or hallway. NOTE: Doors or openings to the rooms required to be accessible may be wider and the notch or alcove smaller if equivalent access is not impeded. In addition,for a doorway at the end of a hallway,or in other circumstances,the notch or alcove need not be centered on the doorway if equivalent access is not impeded. e. Flooring throughout the residential dwelling unit consistent with CBC Chapter 11A. f. Standards pertaining to residential structures from ANSI A117.1 may be used throughout this chapter when CBC Chapter 11A does not contain specific standards or when the ANSI standards are equivalent to the Chapter 11A standards. 20.75.140 Standards—new construction—permissive options. A. The developer or builder of a visitable residential dwelling must offer an opportunity to select any of the features listed in this chapter to an owner or prospective owner of a visitable residential dwelling at the earliest feasible time after the owner,purchaser, or prospective purchaser is identified. B. The developer or builder of a visitable residential dwelling shall construct or install any requested features identified in this chapter unless it would result in an unreasonable delay in the construction or significant unreimbursable costs to the developer or builder. C. The developer or builder of a visitable residential dwelling,at his or her option,may offer or utilize standards for structural or design features,components or appliances and facilities, including but not limited to ANSI standards,which meet or exceed Chapter 11A and which offer greater availability, access or usability,and these are deemed to be in compliance with this chapter. 20.75.150 Enforcement. A. It is unlawful for any person or entity to fail to comply with the requirements of this chapter. Universal Design City Council, September 20 2022 Exhibit A to Ordinance, PMC Amendments,Page 8