PC-2019-10 - Laserfiche WebLink

25. MECHANICAL EQUIPMENT— SCREENING: The applicant shall effectively screen from view all ducts, meters, air conditioning equipment, and any other mechanical equipment, whether on the structure, on the ground, or on the roof, with materials architecturally compatible with the building. Screening details shall be shown on the plans submitted for building permit, the adequacy of which shall be determined by the Director of Community Development. All required screening shall be installed prior to final occupancy. 26. TRASH ENCLOSURE: All trash and refuse shall be contained completely within enclosures. Containers shall be stored within the enclosures at all times except when being unloaded. The enclosures shall be sized to accommodate trash, recycling, and green waste containers. The materials and colors of any new enclosures shall match or be compatible with the adjacent building and the gates shall be metal or solid wood unless otherwise approved by the Director of Community Development. Elevation drawings and plan details, including color and material of the enclosures noted, shall be included in the building permit submittal and shall be subject to the review and approval of the Director of Community Development prior to building permit issuance. 27. RECYCLING AND COMPOSTING PROGRAMS: The project shall comply with the current City/Pleasanton Garbage Service recycling and composting programs. 28. GREEN BUILDING — NON-RESIDENTIAL NEW CONSTRUCTION: Prior to building permit issuance, a list of the green building measures used in the design, covered by this approval, shall be provided to the Planning Division for review and approval by the Director of Community Development. The project shall be designed, constructed and operated to achieve a "certified rating," achieving at least the minimum points in each category, using U.S. Green Building Council's "Leadership in Energy and Environmental Design (LEED)" rating system. The green building measures shall be shown on the building permit plans submitted to the Building and Safety Division. Each proposed point identified shall have a notation indicating the sheet(s) the point can be found. A special inspection by the Planning Division shall be coordinated with regards to exterior materials. Prior to building permit final, all of the green building measures indicated on the approved checklist shall be inspected and approved by either the City of Pleasanton, a third party rater, or the applicant shall provide written verification by the project engineer, architect, landscape architect, or designer. (Per PMC 17.50) 29. PHOTOVOLTAIC SYSTEM: The buildings shall be constructed to allow for future installation of a photovoltaic (PV) system. The project applicant shall comply with the following requirements for making the buildings photovoltaic-ready: a. Electrical conduit and cable pull strings shall be installed from the roof/attic area to the building's main electrical panels; b. An area shall be provided near the electrical panel for the installation of an "inverter" required to convert the direct current output from the photovoltaic panels to alternating current; and c. Engineer the roof trusses to handle an additional load as determined by a structural engineer to accommodate the additional weight of a prototypical photovoltaic system beyond that anticipated for roofing. These measures shall be shown on the building permit plan set submitted to the Director of Community Development for review and approval before issuance of the building permit. P18-0340 Planning Commission Page 5 of 20 ing Commission Page 4 of 20 or the rented units. (PROJECT SPECIFIC CONDITION) P18-0109 Planning Commission Page 4 of 13