ORD 2174 - Laserfiche WebLink

EXHIBIT A 59. Any damage to existing street improvements during construction on the subject property shall be repaired to the satisfaction of the City Engineer at full expense to the project developer and includes but is not limited to slurry seal, overlay, restoration of landscaping and irrigation system, signing, striping, pavement marking or street reconstruction if deemed warranted by the City Engineer. 60. This approval does not guarantee the availability of sufficient water and/or sewer capacity to serve the project. 61. There shall be no direct roof leaders connected to the street gutter or storm drain system, unless otherwise approved by the City Engineer. 62. The project developer and/or the project developer's contractor(s) shall obtain an encroachment permit from the City Engineer prior to moving any construction equipment onto the site. 63. The project developer shall submit a final grading and drainage plan prepared by a licensed civil engineer depicting all final grades and drainage control measures, including concrete-lined V-ditches, to protect all cut and fill slopes from surface water overflow. This plan shall be subject to the review and approval of the City Engineer prior to the issuance of a subdivision grading permit. 64. The project developer shall include erosion control measures on the final grading plan, subject to the approval of the City Engineer. The project developer is responsible for ensuring that the contractor is aware of such measures. All cut and fill slopes shall be revegetated and stabilized as soon as possible after completion of grading, in no case later than October 15. No grading shall occur between October 15 and April 15 unless approved erosion control measures are in place, subject to the approval of the City Engineer. Such measures shall be maintained until such time as a permanent landscaping is in place. 65. A detailed grading and drainage plan prepared by a licensed Civil Engineer including all supporting information and design criteria (including but not limited to any peer review comments), storm drain treatment calculations, hydromodification worksheets, etc., shall be submitted as part of the improvement plans. Building and Safety Division 66. Prior to issuance of building or demolition permits, the applicant shall submit a waste management plan to the Building and Safety Division. The plan shall include the estimated composition and quantities of waste to be generated and how the project developer intends to recycle at least 75 percent of the total job site construction and demolition waste measured by weight or volume. Proof of compliance shall be provided to the Chief Building Official prior to the issuance of a final building permit. During demolition and construction, the project developer shall mark all trash disposal bins "trash materials only" and all recycling bins "recycling materials only." The project developer shall contact Pleasanton Garbage Service for the disposal of all waste from the site. Page 9 of 16