PC-2010-05, PAP-142/PDR-885, PHIL BENZEL, ROBERT MILLER AND TODD BRIGGS

be designed to achieve a "certified rating" of a minimum of 50 total points, achieving at least the minimum points in each category, using BuildltGreen's current GreenPoints rating system. The green building measures shall be shown on one of the first two pages of the plans submitted for issuance of a building permit. Each point identified shall have a notation indicating the sheet where the point can be found, and each sheet shall note where the point is located. All proposed green building measures shall be shown throughout the plan set, as appropriate, as determined by the Director of Community Development. A special inspection by the Planning Division shall be coordinated with regard to landscaping, irrigation, and exterior materials. All of the green building measures indicated on the approved checklist shall be inspected and approved by either the City of Pleasanton or a third -party rater, or the applicants shall provide written verification by the project engineer, architect, landscape architect, or designer. 17. The home covered by this approval shall be provide telecommunication infrastructure consistent with state-of-the-art methods including 100 base T with separate junction boxes, e.g., cabling for DSL service, wiring for total room access, etc. The project developer shall include those measures in the home construction for review and approval by the Director of Community Development prior to the issuance of a building permit. 18.All residences in the PUD shall be constructed to allow for future installation of a Photovoltaic (PV) system. The project/building developer shall comply with the following requirements for making all units on the subject site photovoltaic -ready. Making units photovoltaic -ready shall require the following measures to be implemented with the construction of the structures covered: 19. Electrical conduit and cable pull strings shall be installed from the roof/attic area to the buildings' main electrical panels: 20. An area shall be provided near the electrical panel for the installation of an "inverter" required to convert the direct current output from the photovoltaic panels to alternating current. Building and Site Design Requirements: 21. Prior to first framing inspection, the height of the primary structure shall be surveyed and verified as being in conformance to the approved building height of 30 feet from the lowest grade. Said verification is the project developer's responsibility. The height verification shall be performed by a licensed land surveyor or civil engineer and shall be completed and provided to the Planning Division before the first framing or structural inspection by the Building and Safety Division. The height shall L;