PC-98-57 - Laserfiche WebLink

55. The paving sections for the on-site parking and drive areas shall be designed on the basis of an "R- Value" test and a traffic index to carry the anticipated traffic loads. This design shall be subject to the approval of the Director of Building Inspection. The minimum paving section shall be two inches (2") of asphalt concrete (A.C.) on a six inch (6") asphalt base (A.B.). The minimum A.C. pavement slope shall be one percent (I %). For pavement slopes less than one percent (I %), the surface runoff shall be carried in a concrete gutter to an acceptable point of discharge. The minimum slope for concrete gutter shall be 0.5%. 56. The project developer shall install street frontage improvements along Stoneridge Mall Road per Chapter 19.40.010 of the Pleasanton Municipal Code and to the sat- isfaction of the City Engineer. These improvements may include, but are not nec- essarily limited to, grading, curb and gutter, sidewalk, paving, storm drain, sanitary sewer, water facilities, street lighting, underground utilities, traffic control devices, landscaping, and automatic irrigation systems. 57. The project developer shall submit a final grading and drainage plan prepared by a licensed civil engineer depicting all final grades and on-site drainage control meas- ures, including concrete-lined "V" -ditches, to protect all cut and fill slopes from surface water overflow. This plan shall be subject to the review and approval of the City Engineer and/or the Director of Building Inspection prior to the issuance of any building permits. 58. The project developer shall submit a refundable cash bond for hazard and erosion control prior to issuance of an Engineering Department or Building Department permit. The amount of this bond will be determined by the City Engineer. 59. The project developer shall dedicate to the City for street right-of-way purposes those parcels of land intended to be public streets. 60. The project developer shall grant an easement to the City over those parcels needed for public service easements (P.S.E.) and which are approved by the City Engineer or other easements which may be designated by the City Engineer. 61. The design for the line, grade, and structural sections for the streets serving this development shall be subject to final review and approval by the City Engineer. 2-98-071. Safeway Headquarters Exhibit "B", Final Conditions of Approval per Planning Commission July 22, 1998 Page 12 of 17