Laserfiche WebLink
• <br /> 9. Development standards shall be as follows: <br /> Site Development Standard Proposed <br /> Maximum Floor Area Ratio' 40% (lots 1-2) <br /> 25% (lot 3) <br /> Maximum Height** 30 feet <br /> Minimum Principal Structure Setbacks <br /> Front '23 feet <br /> Side <br /> Interior side Lots 1 and 2: 10 feet <br /> Lots 3 and 4: 5 feet (east) <br /> 15 feet (west) <br /> Street side Lot 2: 15 feet <br /> Rear 20 feet <br /> Minimum Accessory Structure Setbacks (Class I) <br /> Front Not allowed between the front <br /> of the house and the front <br /> property line. <br /> Side 3 feet (interior) <br /> 10 feet (street side) <br /> Rear 5 feet <br /> Maximum Accessory Structure 15 feet <br /> Height <br /> * FAR calculation excludes 600 sq.ft. of garage area. <br /> **Measured from the lowest finished grade adjacent to the house to the highest point of <br /> the building excluding chimneys. <br /> 10. Unless otherwise specified in the conditions of approval or shown on the PUD development <br /> plan, site development standards shall be those of the R-1-10,000 District. <br /> 11. New homes and additions or exterior alterations to existing homes within this PUD shall be <br /> subject to the Design Guidelines, dated "Received March 31, 2016" on file with the Planning <br /> Division. Modifications to the approved design guidelines are subject to the approval by <br /> the Director of Community Development. At the discretion of the Director of Community <br /> Development, it may be referred to the Planning Commission for approval. <br /> 12. The design guidelines shall be modified to require: 1) homes be designed in Craftsman <br /> style instead of "rural ranch" style, where second-story elements are deemphasized, and <br /> 2) covered porches be incorporated into home design. The final design guidelines shall be <br /> Case No. PUD— 112/1027 Rose Avenue Planning Commission <br /> Page 2 <br />