SUPPLEMENTAL MATERIAL - Laserfiche WebLink

33% I 17% 34% 16% 35% 15% 36% I 14% 37% 13% 38% 12% 39% I 11% 40 %+ I 10% Table 3 -6.2 Single Family Residential Building Size Limits for New Lots Recorded after Enactment of Ordinance No. 1480, Dated 1/13/04 Average Slope of Lot I Maximum Allowable Floor Area Ratio 10% 40% 11% 39% 12% I 38% 13% 37% 14% 36% 15% 35% 16% 34% 17% 33% 18% I 32% 19% 31% 20% 30% 21% 29% 22% 28% 23% 27% 24% 26% 25% I 25% 19.26 J. Siting and Height Limitations. Structures that are placed adjacent to ridgelines or knolls shall comply with the following provisions in addition to those required by Article 2 (Zoning Districts, Allowable Land Uses, and Zone Specific Standards) and section 19.20.070 (Height Limits and Exceptions): 1. Siting Restrictions. Structures shall not be placed so that they are silhouetted against the sky when viewed from a public street, except where the review authority determines that the only feasible building site on an existing lot cannot comply with this standard. See figure 3 -11. 2. Placement Below Ridgeline Required. Structures shall be located so that a vertical separation of at least 25 feet is provided between the top of the structure and the top five -foot contour of the ridge or knoll to maintain the natural appearance of the ridge. See figure 3 -12. Where the review authority determines that a parcel contains no feasible building site other than where a structure will extend above the ridgeline, proposed structures shall not exceed a height of feet above the highest point on the ridgeline or hilltop within 100 feet of the proposed structure. Height Measurement. The maximum allowable building height shall be measured in compliance with section 19.20.070 Height Limits and Exceptions), with the exception that either the existing pre - developed grade, or the finished grade, whichever has the lower elevation, shall be utilized. 8