01 - Laserfiche WebLink

EXHIBIT A manufacturer of the synthetic grass system is not the same entity as the contractor, the warranty shall be co-signed by the manufacturer and the installation contractor. 1.11 FORM OF WARRANTY OF THE SYNTHETIC GRASS SYSTEM A. Contractor hereby warrants to the City of Pleasanton, subject to the limitations and conditions set forth below, that its synthetic grass system consisting of the synthetic turf described as AstroTurf GameDay DT-32, the shock-absorbing under-pad described asl5mm Brock SP, and the adhesives used in the installation, are free from defects in material and workmanship and shall, for a period of eight (8) years from the date of acceptance by the City of Pleasanton, remain serviceable for the activities as listed above. B. Contractor warrants to the City of Pleasanton that its synthetic grass materials shall not fade, fail, shrink, wrinkle or reflect excessive wear. Contractor shall, at their sole expense and cost, replace such areas of the synthetic grass system not performing to these standards for the life of the warranty. C. Definitions: 1. The term "not fade" in the context of this warranty shall mean that the synthetic grass material remain a uniform shade of green or the other colors installed with no significant loss of color as defined by not greater than 20% loss or shade reduction. 2. The term "not fail" or "excessive wear" as used in the context of this warranty shall mean that the length and weight of the face yarn or pile material in the synthetic turf surface shall not have been decreased by more than 8% per year according to ASTM D418, nor exceed 20% during the warranty period. In the event that the synthetic turf materials do not retain its fiber height or shock absorbency and is consequently no longer serviceable during the warranty period, the Contractor shall, at their sole expense, replace such portions of the system that are no longer serviceable. 3. The term "serviceable" in the context of this warranty shall mean that the synthetic turf material shall have a maximum "'G" force value according to Procedure A, B, or C of ASTM D355, not exceed 110 G's at any location upon installation and shall not exceed 150 G's thereafter throughout the life of the warranty period. This shall be determined by conducting dynamic cushioning tests at the six field locations as required per ASTM D355 procedures. "G" force factor values to be determined at 70 degrees F. Any increase from 110 G's to allowable 150 G's maxium shall be at a relatively uniform rate not to exceed 10 G's in any single year. D. Where applicable, the fabric shall adhere firmly and completely to the underpad or seaming tape over the entire warranty period.