05 - Laserfiche WebLink

and ensure that all construction workers are aware of the location of the line. The location of the pipeline shall be noted on the site and construction plans. Further, the project contractor shall take all appropriate measures necessary to ensure that the line is not disturbed. 83. In accordance with measure HZ-2.1, the project developer shall develop an emergency response plan prior to construction that will include response measures in the event that there is disturbance of any underground utilities. The plan will be subject to review and approval by the Building and Safety Division and/or City Engineer. 84. In accordance with measure HY-1.1, and in accordance with the applicable provisions of the Municipal Regional Permit (MRP)-NPDES Permit, implementation of and compliance with the stormwater quality BMPs are required. However, to ensure that implemented BMPs are effective for reducing potential pollutant loads to a sufficient level of protection, each project developer shall prepare and implement a site-specific Water Quality Management Plan (WQMP) with BMPs targeted to reduce post-construction pollutants listed in Table 3.5-5 of the EIR. This WQMP shall identify specific stormwater BMPs for reducing potential pollutants in stormwater runoff. BMPs shall be selected to target pollutants listed in Table 3.5-5 of the EIR; selection criteria and documentation shall be incorporated into the WQMP. A qualified engineer shall prepare and submit, concurrently with the submittal of off-site or on-site improvement plans, (whichever comes first), the WQMP for review and approval by the City Engineer. The WQMP must be approved by a qualified engineer of the City's Engineering Division prior to the beginning of construction activities. The WQMP shall include the following BMPs along with selected BMPs to target pollutant removal: a. Waste and materials storage and management BMPs (design and construction of outdoor materials storage areas and trash and waste storage areas, if any, to reduce pollutant introduction). b. Spill prevention and control BMPs. c. Slope protection BMPs. d. Water efficient irrigation practices. e. Permanent erosion and sediment controls (e.g., hydroseeding, mulching, surface covers). Projects within the Project Area will be required to comply with the applicable provisions C3.c of MRP, including Low Impact Development (LID) source control, site design, and stormwater treatment if applicable. The WQMP shall not include infiltration BMPs unless they comply with design guidelines and requirements specified in TC-1: Infiltration Basins in the CASQA PUD-106, Chrylser-Jeep-Dodge Page 15