ORD 2103 - Laserfiche WebLink

Prevention Bureau. All systems shall be point identified by individual device and annunciated by device type and point. 104. The Fire Prevention Bureau reviews building/civil drawings for conceptual on-site fire mains and fire hydrant locations only. Plan check comments and approvals DO NOT INCLUDE: • Installation of the on-site fire mains and fire hydrants. Specific installation drawings submitted by the licensed underground fire protection contractor shall be submitted to the Fire Prevention Bureau for approval. • Backflow prevention or connections to the public water mains. 105. Electrical conduit shall be provided to each fire protection system control valve including all valve(s) at the water connections. The Livermore-Pleasanton Fire Department requires electronic supervision of all valves for automatic sprinkler systems and fire protection systems. 106. On-site access ways and internal drives shall be designated as fire lanes and identified as such by red curb striping and posted with signs at locations approved by the Fire Department. Signs shall be according to state standards and read "No Parking - Fire Lane" and must be shown on the plans. The following schedule shall apply: Width Requirements 36 Feet or Greater No Requirements Between 28 and 36 Feet Post one side Between 20 and 28 feet Post both sides Less than 20 feet Not permitted Where Fire Department vehicle access through or around a site involves changes in direction or curves, minimum-turning radius shall be as follows. Inside radius of 45 feet and outside radius of 55 feet shall be provided to facilitate fire truck turning radius for entry and exit from the site. 107. Dead-end access ways and internal drives shall not exceed 300 feet in length and shall terminate in turnaround no less than 100 feet in diameter or hammer-head (tee). Standards and options are available through the Fire Prevention Bureau. 108. Address numbers shall be installed on the front or primary entrance for all buildings. Minimum building address character size shall be 12 inches high by 1-inch stroke. If building is located greater than 50 feet from street frontage, character size shall be 16 inches high by 1 1/2 inches stroke minimum. Where multiple access is provided, address or tenant space number shall be provided on each access and/or warehouse door and character size shall be no less than 4 inches high by %-inch stroke. In all cases address numerals shall be of contrasting background and clearly visible in accordance with the Livermore-Pleasanton Fire Department Premises Identification Standards. This may warrant field verification and adjustments based upon topography, landscaping or other obstructions. conditions of approval checklist shall be completed and attached to all plan checks submitted for approval indicating that all conditions have been satisfied. PUD-101 (Kottinger Gardens) City Council 19 of 22