ORD 2058 - Laserfiche WebLink

Lot 1 Lot 2 Lot 3 Lot 4 45 ft. (1s'floor) 51 ft. to bldg. 45 ft. 45 ft. Front 71 ft. (2nd floor) 43 ft. to porch __ 15 ft. east side 15 on either side 15 ft. east side 15 ft. west side Side 55 ft. driveway 29 ft. driveway 20 ft. driveway (east) (west) side (west) side side __ Rear 25 ft. 25 ft. 25 ft. from top of the 25 ft. from top of the creek bank creek bank Bldg. Area 5,500 sq.ft. max 5,000 sq.ft. max. 5,500 sq.ft. max. 5,500 sq.ft. max. Max Height 27'6" 28' 27'3" 27'3" Note: 1) The yard determination for each lot shall be those shown in Exhibit B. 2) Setback measurements are taken from property lines. 3) Front yard setback for Lot 1: 45 feet to the one-story portion of the home and 71 feet to the second-story portion of the home. 4) The posts of open porches are allowed to encroach no more than five feet into the required 25-foot rear yard setback area. 5) Maximum building area includes primary and Class I accessory structures but excludes up to 600 square feet of garage area. Portions of garage floor area over 600 square feet would be included in the building area calculation. 6) Height measurement is taken from the finished grade to the highest point of the structure. 19. Unless specified above, the site development standards of the R-1-20,000 District shall apply. 20.Appliances meeting Energy Star standards shall be installed as part of the project. The proposed appliances shall be indicated on the plans submitted for the issuance of a building permit. 21.Water conservation devices such as low-flow faucets, toilets, shower fixtures, etc. shall be installed as part of the project. The devices shall be indicated on the plans submitted for the issuance of a building permit. 22. The electrical plan for the homes shall provide telecommunications infrastructure consistent with state-of-the-art methods (e.g. cabling for DSL, broadband, or wireless service, wiring for total room access, etc) in effect at the time that building permit(s) are issued. The plan shall be part of the building permit plan set. 23. The project developer shall specify the details of windows and doors (manufacturer, style/model, etc.) on the construction drawings submitted for plan check. The details shall include a one-inch window recess as measured from the siding not the window sill/trim. The details shall be subject to review and approval by the Director of Community Development prior to issuance of building permits for the project. 24. The front yard fence on Lot 1 shall be revised from the proposed 30-inch high solid fence to a 36-inch high split rail fence. This revision shall be reflected on