ORD 2036 - Laserfiche WebLink

c. Gather all sorted construction debris on a regular basis and place it in the appropriate container for recycling; to be emptied at least on a weekly basis. When appropriate, use tarps on the ground to collect fallen debris or splatters that could contribute to stormwater runoff pollution. d. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm drains adjoining the site. Limit construction access routes onto the site and place gravel on them. Do not drive vehicles and equipment off paved or graveled areas during wet weather. Broom sweep the street pavement adjoining the project site on a daily basis. Scrape caked- on mud and dirt from these areas before sweeping. e. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing in the storm drain system. Maintain and/or replace filter materials to ensure effectiveness and to prevent street flooding. f. Create a contained and covered area on the site for the storage of cement, paints, oils, fertilizers, pesticides, or other materials used on the site that have the potential of being discharged into the storm drain system by wind or a material spill. g. Never clean machinery, equipment, tools, brushes, or rinse containers into a street, gutter, soil/dirt or storm drain. h. Ensure that concrete/gunite supply trucks or concrete/plaster operations do not discharge wash water into street, gutters, and/or unprotected soil or storm drains. i. Equipment fueling area: Use off-site fueling stations as much as possible. Where on-site fueling occurs, use designated areas away from the storm drainage facility, use secondary containment and spill rags when fueling, discourage "topping off' of fuel tanks, place a stockpile of absorbent material where it will be readily accessible, and check vehicles and equipment regularly for leaking oils and fuels. Dispose rags and absorbent materials promptly and properly. j. Concrete wash area: Locate wash out areas away from the storm drains and open ditches, construct a temporary pit with impermeable liner large enough to store the liquid and solid waste, clean pit by allowing concrete to set, breaking up the concrete, then recycling or disposing of properly. Remove dried concrete on a regular basis (so liner below the wash area will not split and allow wash water to mix with soil). Use self cleaning concrete trucks where available. k. Equipment and vehicle maintenance area: Use off-site repair shop as much as possible. For on-site maintenance, use designated areas away from the storm drainage facility. Always use secondary containment and keep stockpile of cleanup materials nearby. Regularly inspect vehicles and equipment for leaks and repair quickly or remove from the project site. Train employees on spill cleanup procedures. In case of spill contact project QSD or QSP and follow the procedure required in State NPDES General Permit. Operation Requirements 172. The Permit's operation and maintenance requirements include but are not limited to the following: The operation and maintenance of treatment measures including, but not limited to, bio-swales, lawns, landscaped areas with deep-rooted plants, oil/water separator, Filterra units, etc., (requires completing, signing, and recording an agreement with Alameda County recorder's office in a format approved by the State and Alameda County). PUD-81-30-86D and P11-0856 Hacienda TOD Site Z BRE Conditions of Approval 23 of 24 Mixed-Use Development