ORD 2036 - Laserfiche WebLink

District (DSRSD) upon installation of the sanitary connection; a copy of this notification shall be provided to the Planning Division. f. All paved outdoor storage areas shall be designed to minimize pollutant runoff. Bulk materials stored outdoors that may contribute to the pollution of stormwater runoff must be covered as deemed appropriate by the City Engineer/Chief Building Official and as required by the State Water Board. g. All metal roofs, if used, shall be finished with rust-inhibitive paint. h. Roof drains shall discharge and drain away from the building foundation. A minimum of ten percent of the stormwater flow shall drain to landscaped areas or to an unpaved area wherever practicable. Construction Requirements 169. The Construction General Permit's construction requirements include, but are not limited to, the following: The project developer shall submit a Stormwater Pollution Prevention Plan (SWPPP) as per requirements in NPDES General Permit for Storm Water Discharges Associated with Construction and Land Disturbance Activities, Section XIV of the Order 2009-0009-DWQ for review by the City Engineer/Chief Building Official prior to issuance of any building or engineering permits. A reviewed copy of the SWPPP shall be available at the project site until engineering and building permits have been signed off by the inspection departments and all work is complete. A site specific SWPPP must be combined with proper and timely installation of the Best Management Practices (BMPs), thorough and frequent inspections, maintenance, and documentation. Failure to comply with the reviewed construction SWPPP may result in the issuance of correction notices, citations, and/or stop"work orders." 170. The amendments to the SWPPP and all the inspection forms shall be completed and available at the site for inspection by the City, County or State staff. 171. The project developer is responsible for implementing the following Best Management Practices (BMPs). These, as well as any other applicable measure, shall be included in the SWPPP and implemented as approved by the Project Qualified SWPPP Developer(QSD). a. The project developer shall include erosion control/stormwater quality measures on the final grading plan which shall specifically address measures to prevent soil, dirt, and debris from entering the storm drain system. Such measures may include, but are not limited to, rocked construction entrance, hydroseeding, hay bales, sandbags, straw wattles, etc. and are subject to the review and approval of the project Qualified SWPPP Developer. If no grading plan is required, necessary erosion control/stormwater quality measures shall be shown on the site plan submitted for an on-site permit, subject to the review by the Building and Safety Division. The project developer is responsible for ensuring that the contractor is aware of and implements such measures under direct supervision of the project QSD or Qualified SWPPP Practitioner(QSP). b. All cut and fill slopes shall be revegetated and stabilized after completion of grading, but in no case later than October 15. Hydroseeding shall be accomplished before September 15 and irrigated with a temporary irrigation system to ensure that the grasses are established before October 15. No grading shall occur between October 15 and April 15 or when rain is in the forecast unless approved erosion control/stormwater quality measures are in place, subject to the approval of the project QSD or QSP. Such measures shall be maintained until such time as permanent landscaping and post construction storm water treatment measures are in place. PUD-81-30-86D and P11-0856 Hacienda TOD Site 2, BRE Conditions of Approval 22 of 24 Mixed-Use Development