ORD 2007 - Laserfiche WebLink

fencing and walls, including the wall on the berm, shall be installed prior to the occupancy of any building on site. b. Prior to the issuance of a building permit, the plans shall be revised to show the existing soundwall along the western property line. Privacy fencing is not required to be installed on the east side of the existing soundwall. c. The pink split face wall color is not approved. Prior to the issuance of a building permit, the applicant shall revise the plans and remove this color from the plan set. d. The wall on the shared boundary line with Hendrick Automotive Group (PUD-57) shall be eight feet in height. The wall may be a brown split-face block wall or the off-white wall shown on sheet 23 of Exhibit B for PUD-57. Prior to the issuance of a building permit, the plans shall be revised to show the proposed wall design and the location of the wall. The design and location shall be subject to the review and approval of the Planning Manager. e. Walls and solid privacy fencing shall not be located on the existing PG&E and Zone 7 easements by 1-580. The plans shall be revised to address this, prior to the issuance of a building permit. f. Prior to the issuance of a building permit, the applicant shall obtain an easement from the property owner to the east such that it can access and maintain the wall around the Central Plant storage yard and around the emergency generator by the storage yard. The easement language shall be subject to the review and approval of the City Attorney, prior to the issuance of a building permit. If an easement cannot be obtained, then the walls shall be setback a minimum of five feet from the eastern boundary line. g. The berm retaining wall shall be designed such that no weight of the berm or retaining wall is transferred to the Zone 7 Cross Valley Transmission Pipeline. h. The footing of the berm retaining wall shall be located such that it is not located in Zone 7's easement area. The location of the footing shall be subject to the review and approval of the City Engineer, prior to the issuance of a building permit. 8. Car Wash Area. If a common car wash area is provided, the car wash area shall be covered and drained through an oil grease separator/sand silt filter to the sanitary sewer, subject to approval by DSRSD. If the area is connected to the sanitary sewer, a sign shall be posted prohibiting the dumping of hazardous materials. No other area shall drain to the car wash area; a berm shall be installed Conditions of Approval/PUD-68 Project-Specific Conditions 10