PC 2002-53 - Laserfiche WebLink

b. Roof structures shall be engineered to handle an additional load of five pounds (5- lbs.)per sq. ft. beyond that of the anticipated for roofing. c. An area shall be provided in the electrical room for the inverter required to convert the direct current output from the photovoltaic panels to alternating current. d. A bi-directional electrical meter shall be installed. These measures shall be shown on the building permit plan set submitted to the Planning Director for review and approval before issuance of the first building permit. 22. The gable roof element shown in Exhibit "D" shall be added to both sides of the roof of the canopy structure. This change shall be shown on the building permit plan set to the satisfaction of the Planning Director before issuance of a building permit. 23. The vent pipes from the underground fuel storage tanks shall be screened from view in a manner to the satisfaction of the Planning Director. However, lattice screens may not be used. This detail shall be shown on the building permit plan set to the satisfaction of the Planning Director before issuance of a building permit. 24. The project developer shall raise the height of the screen wall located between the drive- through lanes and the east property line of the project site to fifty-four inches (54") refer- enced from the height of the driveway. This change shall be shown on the building per- mit set to the satisfaction of the Planning Director before issuance of a building permit. Building and Site Design Requirements: 25. The project developer shall effectively screen from view all ducts, meters, air condition- ing equipment, and any other mechanical equipment, whether on the structure, on the ground, or on the roof, with materials architecturally compatible with the main structure. Screening details shall be shown on the plans submitted for issuance of building permits, the adequacy of which shall be determined by the Planning Director. All required screen- ing shall be provided prior to occupancy. 26. The project developer shall post address numerals on the buildings so as to be plainly visible from all adjoining streets or driveways during both daylight and night time hours. Tenant spaces shall be identified as determined by the City. 27. All mechanical equipment shall be located on the roof of the structure covered by this approval, in the area designated on the roof plan, and shall not project above the horizon- tal plane established by the surrounding equipment screens. This requirement can be modified by the Planning Director if it can be demonstrated with lines-of--sight analyses taken from across Whispering Oaks Way that the mechanical equipment will not be visi- ble. The mechanical equipment shall be designed and maintained so that noise emanating PUD-02-4M& PCUP-61 Page 5 ojl7 Planning Commission Recommendation