05 - Laserfiche WebLink

Exception: When three sides of the panel are attached to the structure, the UI limitations may be removed. A transom shall be considered the same as a header or ceiling mount and shall be secured with channel or clips on 4 sides. 2410.5 Mechanical Fastening Hardware (metal clips, header, tube bracing or channels) 2410.5.1 Metal Clips. U Channels shall be fastened to the finished shower wall. The only permitted penetration through the finished shower wall shall be the mounting screws for clips, channels, and hinges. Reglet design is not recommended. 2410.5.2 Clip Location. Clips on the long edge of the glass shall be located between 4 inches (102 mm) and 8 inches 203 mm) from each end of the glass. A third clip shall be on the long edge if the glass exceeds 48" in length. Clips shall be centered on the short edge on panels up to 16 inches (406 mm) in width. For greater widths, two clips shall be used, one at each one -third point. 2410.5.3 Non -Load Bearing Side Panels. Non -load bearing side panels shall be mounted by mechanical fasteners on the bottom and the top or bottom and one vertical side. Exception: For two in -line side panels (such as a buttress design) and /or to a return panel, the vertical butt joint(s) shall be sealed with a structural silicone sealant and shall be secured at the top with a joint spanning clip(s) or header. 2410.5.4 Load - bearing side panels. Load - bearing side panels and any return panel shall be secured with mechanical fasteners on three sides. The minimum width of a load- bearing panel shall be 5 inches (127 mm). 20.08.170 CBC Chapter 31B adopted and amended — Public Swimming Pools. Chapter 31 B is adopted and amended to add the following Sections to read as follows: Section 3118B.3.1 Existing pool and spa enclosures. Any new or replacement swimming pool, spa, swimming pool /spa enclosure shall be constructed and maintained per the current requirements in Chapter 31B of the California Building Code. Any existing swimming pool, spa, swimming pool /spa enclosure repair may maintain the existing barrier and latch height requirements in place at the time of the original lawfully permitted construction approval. Section 3118B.5 Barrier prerequisite to filling of pool. An inspection to verify pool barriers are installed, functional and in compliance with the current laws and approved plans shall occur and be approved by the Building and Safety Official before water may be introduced into any public pool or spa. 40