05 - Laserfiche WebLink

2410.1.3 Towel Bars and Handles. Horizontal bars and handle shall not be mounted to the interior of the glass surfaces. A vertical handle may be mounted to the interior of the door. 2410.1.4 Hinged Doors. Hinged doors shall open outward and provide a minimum of 22 inches (559 mm) clear opening when opened to 90 °. Bi- folding doors: No portion of a bi -fold door may open into the shower area Exception: Self centering doors that swing both ways are permitted provided there is no restriction for the door to open outward to 90 °. 2410.1.5 Steam /Canopied Enclosures. The roof or enclosed glass top of a shower enclosure shall be 3 /8 inch (9.5mm) tempered laminated glass or 3 /8 inch (9.5mm) plastic and shall not exceed 36 inches (914 mm) in the short dimension. 2410.2 Frameless Light Glass Shower Enclosures. 2410.2.1 Minimum Thickness. Frameless Light Hinging and Sliding Shower Doors shall be a minimum of 3 / 18 inch (5.0 mm) tempered glass. 2410.2.2 Size Limitation. Compression hinged doors shall not exceed 28 inch (711 mm) in width. Compression attached rollers to sliding doors shall not exceed 32 inches (813 mm) in width. Neither may exceed 70 inches (1,778 mm) in height. Exception: When 1 /4 inch (6 mm) tempered glass is used with through -glass fastening, hinged doors shall not exceed 36 inches (914 mm) in width and 96 inches (2,438 mm in height. 2410.2.3 Panels. All 3 / 1 6 inch (5.0 mm) or' inch (7mm) panels shall be framed and attached to three sides. 2410.3 Frameless Heavy Glass Shower Enclosures. 2410.3.1 Hinges. Hinge weights shall not exceed the manufacturer's tested maximum load. Each hinge shall be labeled with its load rating and the label may not be removed before inspection. Three hinges are allowed only when a plumb substrate is provided. 2410.3.2 Screws. Stainless steel screws shall be used of minimum size #10 and a length sufficient to make a minimum penetration into the wood frame of 11/4 inch (38 mm). This penetration into the substrate shall be sealed with a non - hardening, asphalt base sealant. 2410.3.3 Minimum Thickness. Hinged shower doors and stationary panels shall be a minimum of 3 /8 inch (10 mm) tempered glass. 2410.3.4 Recommended Clearances. Clearance between a door and panel or door and wall shall be no less than 1 /8 inch (3.2 mm). Clearance at the bottom of the door shall be no less than 3 /18 inch (5 mm) between the exposed glass edge and the curb or threshold. 2410.4 Size Limitation. 2410.4.1 Doors. Shower doors shall not exceed 38 inches (965 mm) in width or 150 lbs. in weight. Exception: These limits may be exceeded only when a licensed engineer submits a stamped calculation. 2410.4.2 Non -load Bearing Panels. 3 /8 inch (10 mm) panels may not exceed 110 (2,794 mm) united inches, width + height (UI). 1/4 inch (12 mm) panels shall not exceed 120 (3,048 mrn) UI, as per AGA.SH1. Height limitation, 84 inches (2,134mm). 39