PC 2001-51 - Laserfiche WebLink

sion may add conditions to prevent a m-occurrence and/or require operations giving rise to the violation to cease. 86. All hazardous materials including solids, liquids, and gases, in either the pure, processed, or waste state, shall be used and stored inside the buildings/structures covered by this development plan approval. 87. Any project developer, business owner, or tenant storing and/or using hazardous materials within a building covered by this approval, shall post National Fire Protection Association (NFPA) 704 identification on the building and/or tenancy according to the adopted City Fire Code. 88. NFPA placards indicating the relative hazard of the facility shall be posted at all times at the en- trances to this building. The placards shall be posted in a location that is clearly visible by fire- fighters. Engineering Requirements: 89. The paving sections for the on-site parking and drive areas shall be designed on the basis of an R-Value test and a traffic index to carry the anticipated traffic loads. This design shall be subject to the approval of the Director of Building Inspection. The minimum paving section shall be two inches (2") of asphalt concrete (A.C.) on a six inch (6") asphalt base (A.B.). The minimum A.C. pavement slope shall be one percent (1%). For pavement slopes less than 1%, the surface runoff shall be carried in a concrete gutter to an acceptable point of discharge. The minimum slope for concrete gutter shall be 0.5%. 90. The project developer shall submit a final grading and drainage plan prepared by a licensed civil engineer depicting all final grades and on-site drainage control measures, including concrete- lined V-ditches, to protect all cut and fill slopes from surface water overflow. This plan shall be subject to the review and approval of the City Engineer and/or the Director of Building Inspec- tion prior to the issuance of any building permits. 91. The project developer shall submit a refundable cash bond for hazard and erosion control prior to issuance of an Engineering or Building Department permit. The amount of this bond will be de- termined by the City Engineer. 92. The project developer shall grant an easement to the City over the portions of the site needed for public service easements (P.S.E.) or other easements which may be designated by the City Engi- neer. Said easements shall be subject to review and approval by the City Engineer and City At- torney and shall be recorded prior to final occupancy. 93. The haul ronte for all materials to and from this development shall be approved by the City En- gineer prior to the issuance of an encroachment permit. 94. The project developer shall include erosion control measures on the final grading plan, subject to the approval of the City Engineer. The project developer is responsible for ensuring that the con- Conditions of Approval PUD-16 Page 13