PC 2001-40 - Laserfiche WebLink

Resolution No. PC-01-40 Page 9 32. The existing retaining wall along the Kottinger Drive frontage shall be removed and a new retaining wall installed. The following conditions shall apply to the new wall: The face of the wall located westerly of the proposed driveway shall be installed two feet behind the back of the curb to allow vehicles parked parallel with the curb to open their car doors, unless otherwise approved by the City Engineer. The wall located easterly of the proposed driveway shall be set behind a 5- foot wide monolithic sidewalk, unless otherwise approved by the City Engineer. Prior to issuance of a building permit, an elevation drawing of the proposed retaining wall shall be submitted to the Planning Department for review and approval. The Planning Director shall approve the wall type and finish. The applicant shall install concrete swales at the top of the wall (on the backside) to intercept overland flows uphill of the wall. The applicant shall submit calculations for the wall to the City's Building Department. 33. The project developer shall submit a pad elevation certification prepared by a licensed land surveyor or registered civil engineer to the Chief Building Official and Planning Director, certifying that the pad and building locations (setbacks) are pursuant to the approved plans, prior to receiving a foundation inspection for the structures. 34. The project developer shall implement the following measures with the construction of the structures covered by this approval so that the owners can install roof-mounted photovoltaic systems in the future: Electrical conduit and cable shall be installed from the roof/attic areas to the buildings' main electrical panels. Roof trusses shall be "engineered" to handle an additional load of five pounds (5-lbs.) per sq. ft. beyond that of the anticipated roofing. An area shall be provided near the electrical panel for the "inverter" required to convert the direct current output from the photovoltaic panels to alternating current. A bi-directional electrical meter shall be installed. These measures shall be shown on the building permit plan set submitted to the Planning Director for review and approval before issuance of the first building permit. The project developer shall provide to the future homebuyers the necessary information delineating the means by which photovoltaic panels can be applied to the roofs of the structures covered by this approval. This information shall be submitted to the Director of Planning for review and approval prior to occupancy of the first unit.