07 - Laserfiche WebLink

67. The project developer/subdivider shall show a proposed typical private driveway section for the on-site development on the tentative map. Said section shall include: curbs or edge treatment of the driveway, private storm drain line including drainage inlets, public water main including fire hydrants, public sanitary sewer, joint trench including lights and utility boxes. The typical section shall also show a public service easement extending across the entire width of the driveway and extend five feet on each side of the driveway for utility boxes. 68. The project developer/subdivider shall install individual water and gravity sanitary sewer laterals to each house site from the public mains. The laterals shall be private, maintained by the individual property owners. There shall be a two-way cleanout on the sanitary sewer lateral located at the back of the Public Service Easement (PSE). 69. There shall be no direct roof leaders connected to the street gutter or storm drain system. Stormwater Desiqn Requirements 70. The project shall comply with the Alameda Countywide NPDES Permit #CA50029831, a copy of which is available at the City offices. The following requirements shall be incorporated into the project: a) The project developer shall submit a final grading and drainage plan prepared by a licensed civil engineer depicting all final grades and on-site drainage control measures including bio-swales. Irrigated bio-swales shall be redesigned as needed to the satisfaction of the City Engineer to optimize the amount of the storm water running off the paved surface that enters the bio-swale at its most upstream end. This plan shall be subject to the review and approval of the City Engineer prior to the issuance of any building permits; b) In addition to natural controls the project developer may be required to install a structural control, such as an oil/water separator, sand filter, or approved equal (in the parking lot) (on the site) to intercept and pre-treat storm water prior to reaching the storm drain. The design, locations, and a schedule for maintaining the separator shall be submitted to the City Engineer/Chief Building Official for review and approval prior to issuance of building permits. The structural control shall be cleaned at least twice a year: once immediately prior to October 15 and once in January. The project developer shall enter into a maintenance agreement for the oil/water separator; c) The project developer shall submit sizing designs criteria to treat stormwater runoff at the time of plan submittal; 12