15 - Laserfiche WebLink

and gate opening system shall be subject to review and approval by the Fire Chief and Director of Planning and Community Development. Enaineerina Requirements 99. Prior to occupancy of the project, the applicant shall design and install a new fl- inch diameter sanitary sewer line in Stoneridge Mall Road from Canyon Way to a point approximately 850-feet to the south, including the connection to the existing 8-inch sanitary sewer main. The final design of the on-site and off-site sewer systems shall be shown on the plans submitted for issuance of building permit and shall be subject to the approval of the City Engineer. The applicant may enter into a reimbursement agreement with the City to recover some of the cost of the eight-inch sanitary sewer main in Stoneridge Mall Road (listed above) from other benefiting properties. 100. The building permit plans shall accurately show all existing public improvements near the subject development (i.e., street lights, street signs, utility vaults and boxes, etc.) and shall clearly indicate any proposed modifications to the existing public improvements. Proposed modifications to the public improvements shall be subject to review and approval by the City Engineer and Director of Planning and Community Development prior to issuance of a building permit. 101. All existing wells on the site shall be removed or sealed, filled and abandoned pursuant to Alameda County Ordinance 73-68, prior to the start of grading operations unless Zone 7 retains specific wells for observation wells, or special approval is obtained from the City Engineer for temporary use of an existing well for construction water. Any wells designated for abandonment or any wells, encountered during construction, are to be destroyed in accordance with a permit obtained from Zone 7. 102. All utilities required to serve the proposed development shall be installed underground in conduit, unless otherwise determined by the City Engineer. 103. The project developer shall submit a refundable cash bond for hazard and erosion control prior to issuance of an Engineering Department or Building and Safety Division permit. The amount of this bond will be determined by the City Engineer. 104. The project developer's contractor(s) shall obtain an encroachment permit from the City Engineer prior to moving any construction equipment onto the site. 105. The haul route for all materials to and from this development shall be approved by the City Engineer prior to the issuance of an encroachment permit. 106. The project developer shall include erosion control measures on the final grading plan, subject to the approval of the City Engineer. The project developer is 16