14 ATTACHMENTS - Laserfiche WebLink

33. The building permit plan check materials will be accepted for submittal only after the ordinance approving the PUD development plan becomes effective, unless the project developers submits a signed statement acknowledging that the plan check fees may be forfeited in the event that the ordinance is overturned or that the design is significantly changed. In no case will a building permit be issued prior to the effective date of the ordinance. 34. All structures covered by this approval shall be constructed to: a. Meet Title 24 state energy requirements, and b. Comply with all codes and ordinances in effect before the Building and Safety Division will issue permits. 35. The project developer shall submit three copies of the site geotechnical report to the Chief Building Official for third party peer review and shall pay for such review at the time specified by the Director, but in all cases before the issuance of a grading permit. 36. Prior to final building permit inspection, a final inspection by the Planning Department is required prior to occupancy. 37. During Construction, the project developer is responsible for implementing the following measures: a. Portable toilets shall be kept as far as possible from existing residences and shall be emptied on a regular basis as necessary to prevent odor. b. Gather all construction debris on a regular basis and place it in a dumpster or other container which is emptied or removed on a weekly basis. When appropriate, use tarps on the ground to collect fallen debris or splatters that could contribute to storm water runoff pollution. c. Remove all dirt, gravel, rubbish, refuse, and green waste from the street pavement and storm drains adjoining the site. Limit construction access routes onto the site and place gravel on them. Do not drive vehicles and equipment off paved or graveled areas during wet weather. Broom-sweep the street pavement adjoining the project site on a daily basis. Scrape caked-on mud and dirt from these areas before sweeping. d. Install filter materials (such as sandbags, filter fabric, etc.) at the storm drain inlet nearest the downstream side of the project site in order to retain any debris or dirt flowing in the storm drain system. Maintain and/or replace filter materials to ensure effectiveness and to prevent street flooding. e. Create a contained and covered area on the site for the storage of bags, cement, paints, oils, fertilizers, pesticides, or other materials used on the site that have the potential of being discharged into the storm drain system through being windblown or in the event of a material spill. 7