2001 APRIL - Laserfiche WebLink

20.08.032 system(s), and trouble signal(s) etc. shall be distinctly different and shall be automatically transmitted to an approved Underwriters Laboratory (UL) Central Station Service as spec- ified in NFPA 72-1996 Edition. 2. All Fire alarm system(s) alarm initiation and signaling shall comply with the provisions in Uniform Fire Code Section 1007.3.3.3. Valve monitoring and water-flow alarm and trouble signals shall be distinctly different and shall be auto- matically transmitted to an approved central station, remote station or proprietary monitoring station as defined by national standards, or, when approved by the building offi- cial with the concurrence of the chief of the fire department, sound an audible signal at a constantly attend- ed location. (Ord. 1806 § 2, 2000) 20.08.034 Section 2320.11.3 Amended -Bracing: Section 2320.11.3 of the California building standards code 1998 edition (24 CCR), and including by reference the uniform building code is amended to read as follows: each end of a braced wall line. 3. All braced wall panels shall be clearly indicated on the plans. 4. Construction of braced wall pan- els shall be by one of the following methods: 4.1 Wood boards of 5/g inch (16 mm) net minimum thickness ap- plied diagonally on studs spaced not over 24 inches (610 mm) on center. 4.2 Wood structural panel sheathing with a thickness not less than s/16 inch (7.9 mm) for 16 inch (406 mm) stud spacing and not less than 3/g inch (9.5 mm) for 24 inch (610 mm) stud spacing in accordance with Ta- bles 23-1 1-A-1 and 23-1V-D-1. 4.3 Fiberboard sheathing 4 foot by 8 foot (1219 mm by 2438 mm) panels not less than '/Z inch (13 mm) thick applied vertically on studs spaced not over 16 inches (406 mm) on center when installed in accor- dance with Section 2315.6 and Table 23-11-J. 4.4 Particleboard wall sheathing panels where installed in accor- dance with Table 23-1V-D-2. (Ord. 1778 § 2, 1999) 1. Braced wall lines shall consist of braced wall panels, which meet the requirements for location, type and amount of bracing specified in Table 23-1V-C-1 and are in line or offset from each other by not more than 4 feet (1219 mm). 2. Braced wall panels shall start at not more than 8 feet (2438 mm) from 20.08.038 Section 1629.4.2 Item #4 Amended -Seismic Zone 4Near-Source Factor: Section 1629.4.2 item #4 of the California building standards code 1998 edition (24 CCR), and including by reference the uniform building '700_1 (Pleasanton April 2001)