PC 2006-05 - Laserfiche WebLink

73. The project developer is responsible for ixrtplexrxex~ting the following measures during all construction phases of-the project: a~ The project developer shall include erosion control/storm water quality measures on the final grading plan which shall specit3cally address measures to prevent soil, dirt, and debris horn entering the storm drain system. Such measures may include, but arc not limited to, hydro seeding, hay bales, sandbags, and siltation fences and are suL~ject to the review and approval of the City L;ngineer/Chief Building Official If no grading plan is required, necessary erosion control/storm water quality nieces ores shall. be shown on the site plan submitted for an on-site permit, subject to the review and approval of the Chief Building O£fici al. The project developer is responsible for ensuring that the contractor is aware of and implements such measures. b) All cut and till slopes shall be revegetated axed stabilized after completion of grading, but in no case later than October 1 5. Hydro seeding shall be accomplished before Scptem ber 15 and irrigated with a temporary irrigation system to ensure that the grasses are established before October 1 5. No grading shall occur between October 1 5 and April 15 unless approved erosion control/storm water quality mcasures are in place, subject to the approval of City 1~;nginecr/Chief Building O£f ci a]- Such measures shall be nzaintaixied until such tviie as permanent landscaping is place. c~ Ci ether all construction debris on a regular basis and place it in a dun~pster or other container which is emptied or removed on a weekly basis- When appropriate, use tarps on the ground to collect fallen debris or splatters that could contribute to storm water runo ££ pollution- d~ Rcx-nove all dirt, gravel, rubbish, refuse, axed green waste from the street pavement and storm drains adjoining the site- Limit con struciion access routes onto the site and place gravel on them- Do not drive vehicles and equipment of£paved or graveled areas during wet weather- Brooxn sweep the street pavexrxent acij oin ing the project site on a daily basis. Scrape caked-on x-nud and dirt from these areas before sweeping. e~ Install filter materials (such as sandbags, filter fabric, etc_ at the storxri drain inlet nearest the downstream side of the project site in order to retain any debris or 3irt flowing in the storx-n drain system. Maintain and/or replace filter n~atcri als to ensure effectiveness and to prevent street tlooding- 17 Create a contained and covered area on 4ze site for the storage of bags, ceiment, paints, oils, fertilizers, pesticides, or other materials used. on the site that have the potential of being discharged into the storm drain system through being windblown or in the event of a material spill 12