ORD 0085 - Laserfiche WebLink

I cottons accompanying the same, to the Town Engineer Subdivision 10. To all Laps made hcreun for approval thereof. The Town Engineer must returv must be attached and run a 3-4 inch galvaniz. said application and specifications, together with his. larger, according to the area of number of i report thereon, before the following meeting of the joined to the inside of the curb, bringing the Town Boad, and said Town Board must at sueh meeting convenient depth according to instructions of acL upon the application therefor. Engineer, front the top of Lhe curb or the ie Subdivision 3. No person, firm or corporation shall ~idewalk; with the so:vice cock to pipe con~ proceed to install any tap unless granted pemnission for (10) inches from the property line, or said ~ so installing said tap by the Board of Trustees, after mx (6) inches below the stirface of the sidev having made application in the manner heroinbefore Subdivision 11. A sheet-iron box, not set forth, and having done all things by this Ordinance. seven (7) inches in diameter, without a bot demanded, prior theerio. be placed around the surface cock, the top o] Subdivision 4. No person or persons shall be al- '~o be of pattern designated by the Town Boar Iowed to do any work upperraining to the tapping oi' tees, and when in position the surface of the the mains of the to~vn water system, excepting such level with the surface of the sidewalk, and to person or persons licensed as plumbers under Ordinance in such position as to be immovable under or, No. 76 of this town. cumstanees. Subdivision 5. All work relative to and appertain- Subdivision 12. After such work is eom' ing to the tapping of the mains shall be done under accepted by the Town Engineer in writing, the supervision of the Town Engineer, and must be i~ making such tap must, within five days them accordance with the terms of this Ordinance. with the Town Clerk the acceptance of s?,id Subdivision 6. Upon completion all work must be and at the same time, but not prior to filing s: left uncovered until inspee~d by the Town Engineer, once, he may, if he so desires, file the bill th and until his approval thereof is given in writing and eeipted by the plumber doing such Work, an{ Hled with the Town Clerk. by the Town Engineer. Subdivision 7. No taps larger than a 3-4 ineli Subdivision 13. The Town Engineer sh~ Standard pipe thread shall be made in any main and prove any bill for the connection of a tap no taps shall be made within ten (10) inches o~ an:., Ordinance, if said bill is in excess of twenty other tap. ~or each and every lineal foot from the to~ Subdivision 8. Each ~ap shaI1 be made as follows: the property line of the property to which The hole for such tap shall be drilled in the top of the connected, in addition to the sum of One Doll~ main, care being taken not to strip threads or otherwise nor shall said Engineer approve any bill for t make a defective joint; and connection thereto must Lion of a tap hereunder which tap is eonne be made with a 3-4 inch corporation union stop cock, the provisions of Section 3 of this Ordinan with eoup!ing to be screwed into the main. A piece of 3--4 inch lead pipe AA thickness, and a{ least !8 inehes Subdivision 14. The cost. of connection { long, to be fastened to the cock, and a one-inch galvan- under the provisions of this Ordinance, exc ized union (smooth face, lead fIanged) to be fastene{I cost of such taps as are connected under the at the other end ,making a perfect joint. of Section 3 hereof, shall be eredied to th~ Subdivision 9. Where a lar~er supply of ~vatm' i~ owner if sOproved by the Town Engineer roquired, two or more taps must be made in the ma;n excess of the amount heroinbefore set fort and joined at a Y or T at the soldering nipple, all ex- division 13 hereof, and be repaid to him at I~ense thereof, however, to be paid by the party making fifty (50) cents per month by deducting th such connection. of fifty (50) cents per month from the am{